Miele DA 272 I, DA 292 I, DA 262 I manual Save These Instructions and Review Them Periodically

Page 6

Warning and Safety instructions

Read these Operating Instructions carefully before installing or

using the Exhaust Hood.

This appliance is intended for residential use only. Use the ap- pliance only for its’ intended pur- pose. The manufacturer cannot be held responsible for damages caused by improper use of the hood.

Read all the instructions before in- stalling or using for the first time.

SAVE THESE INSTRUCTIONS AND REVIEW THEM PERIODICALLY

This appliance is to be used for ventilating cooking smoke / odors

only. Do not use it to vent hazardous or flammable furnes or materials.

Be certain your appliance is properly installed and grounded

by a qualified technician.

To guarantee the electrical safety of this appliance, continuity must

exist between the appliance and an effective grounding system. It is impera- tive that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufac- turer cannot be held responsible for damages caused by the lack, or inade- quacy of, an effective grounding sys- tem.

Do not allow children to play with the hood or its controls.

Repairs on electrical appliances should only be performed by quali-

fied personnel. Do not repair or replace any part of the appliance unless specifi- cally recommended in this manual.

Before servicing, disconnect the power supply by either removing the fuse or manually “tripping” the cir-

cuit breaker.

Do not turn on the hood until it has been proberly installed.

Do not connect the appliance to the main electrical supply using an

extension cord. Extension cords do not meet the safety requirements of this ap- pliance.

Do not cook on an open flame be- neath the exhaust hood. Flames

could be drawn up into the hood by the suction or the grease filters may ignite.

Do not leave the cooktop unat- tended while in use. Overheated

food can ignite.

When installing the hood, make sure that the minimum safety

distances between the cooktop and hood are maintained.

For electric cooktops: 18" (45 cm)

– For gas cooktops:

26" (65 cm)

Only metal ductwork should be connected to the exhaust hood.

Any fittings, sealant, or materials used to install the ductwork must be made of non-flammable materials.

6

Image 6
Contents Operating instructions Cooker hoods DA 262 DA 272 DA 292 Description of the appliance DA 262 DA 272 i / DA 292 Slide switch for ,,Power selec- tion Slide switch for cooktop illumination n Slide switch for the fan m Air extractionContents Help to protect our environment Disposal of packagingDisposal of your old machine Save These Instructions and Review Them Periodically Page Disposal of discarded appliances Operation After cookingCleaning and care CleaningGrease filters Changing the light tube and/or starter Inserting or changing the active charcoal filtersAfter Sales Service Electrical connection For CDN onlyFor USA only Technical data Installation Appliance dimensions Wall unit dimensions 13/16˝Building Depth alignment Preparing the lightshield Removing the transit strips Fitting the light tube coverFitting the cover caps DA 262Only use the template for lightshields Fitting the front facia panel / lightshield DismantlingAir extraction Connection for extractionConnection Calculation of extraction ducting BendAir recirculation Page Page