Cleaning and care
Water tank | Drip tray with grid |
Empty the water tank daily, and fill it with cold fresh water shortly before you start preparing a beverage.
When cleaning, check to be sure that there is no debris in or around the valve. This would prevent the tank from connecting properly, causing it to leak.
^Clean the niche of the water tank.
Waste container
Clean the waste container daily. Typically there will also be some water in the container, left over from the brewing and rinsing processes.
^Slightly lift the waste container, then pull it out of the appliance.
^Wash the container in the dishwasher, or by hand with a mild solution of warm water and liquid dish soap, then dry thoroughly.
^Clean the waster container niche. Be sure to clean the sensors, left and right, the sensors read if the waste container is inserted and if it needs to be emptied.
Do not remove the drip tray from the appliance for a few minutes after the final rinse, as water will still run from the lines.
Use caution when removing the drip tray, the water may be hot. Danger of burns.
Clean the drip tray daily.
^Open the appliance door and carefully remove the drip tray from the appliance.
^Wash the drip tray and the grid in the dishwasher, or by hand with a mild solution of warm water and liquid dish soap, then dry thoroughly.
^Clean and dry the metal sensors at the back of the drip tray. If the sensors are soiled or wet the unit cannot read when the drip tray is full and needs to be emptied.
^Push the drip tray, with the grid inserted, along the right hand side of the opening and to the back of the machine.
^Close the door.
39