Removing a jammed capsule
What if F 75 appears in the display?
The waste container sensors are dirty.
^Remove the waste container and clean the niche, paying special attention to the sensors on the left and right hand sides.
^Place the waste container back in the niche.
The coffee capsule was not pushed onto the capsule plate.
^Remove the carousel tray and capsule plate from the machine.
^Clean the capsule carousel niche. Thoroughly clean the sensor and the recess in the floor. Dry with a soft cloth.
^Return all parts to the machine, then use the main switch to turn the appliance back on again.
^Close the door.
The coffee capsule rests on the capsule plate.
^Open the appliance door.
Turn off the appliance with the main switch.
^Remove the carousel tray and the capsule plate from the machine.
^On the right side of the capsule plate is an opening. Check if a coffee capsule has jammed there.
^Use a wooden spoon handle (only) to push the capsule into the waster container.
^Return the capsule plate, carousel tray and capsule carousel to the machine.
^Turn the appliance on with the main switch.
^Close the appliance door and follow the instructions in the display.
If the fault still appears in the display or the damaged capsule could not be removed easily, contact Technical Ser- vice.
57