Electrical connection
CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power or manually "tripping" the circuit breaker.
Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer will not be held responsible.
Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the rating label correspond with the household electrical supply. This data must correspond to prevent appliance damage. Consult an electrician if in doubt.
Only operate the appliance after it has been installed into the countertop.
Installer:
Please leave these instructions with the consumer.
Power supply
Be sure your electrical supply matches the data plate.
The rating label is located on the underside of the appliance.
The appliance is equipped with a flexible metal conduit encasing 3 wires ready for connection to a grounded power supply.
It must be connected to a dedicated line through the use of an approved junction box.
If the machine is hard wired a separator switch with a contact gap of at least
3 mm must be provided (including switch, fuses and relays). All components must be CSA or UL approved.
Black wire: connect to L1 (hot)
Red wire: connect to L2 (hot)
Green wire: connect to GND (ground)
KM 5621:
208 V, 60 Hz, 40 A fuse rating
240 V, 60 Hz, 30 A fuse rating
KM 5624:
208/240 V, 60 Hz, 40 A fuse rating
KM 5627:
208/240 V, 60 Hz, 50 A fuse rating
Be sure the power outlet is accessible after installation.
For further information, see the wiring diagram provided with the appliance.
WARNING:
THIS APPLIANCE MUST BE GROUNDED!
33