Settings
Volume
Buzzer tones
The volume is represented by a bar with seven segments.
Factory default: Three blocked segments.
To change the volume touch the "quieter" or "louder" sensor.
If all segments are blocked out the volume is on maximum.
If none of the segments are blocked out the volume has been turned off.
Frequency
The frequency of the buzzer can be changed. Changing the frequency may be necessary to optimise the volume in different installation environments.
The frequency range is represented by a bar with 15 segments. Each segment represents a different frequency.
To change the frequency touch the sensor next to the "" or "" symbols.
If the segment on the far left is the only one blocked out (factory default) a brief signal will sound after a short while four times at 15 second intervals.
If more than one segment is blocked out a continual signal will sound after a short while for approx. 8 minutes on the frequency set.
Keypad tone
The volume of the keypad tone, which bleeps when touched, can be changed or the sound switched off completely.
Factory default: Three blocked segments.
To change the volume touch the "quieter" or "louder" sensor.
If all segments are blocked out the volume is on maximum.
If none of the segments are blocked out the volume has been turned off.
50