Care and Cleaning
Proper care and cleaning are important so your range will give you efficient and satisfactory service° Follow these directions carefully in caring for it to help assure safe and proper maintenance.
BE SURE ELECTRICAL POWER IS
DISCONNECTED BEFORE CLEANING
ANY PART OF YOUR RANGE.
Sealed Burner Assemblies
(on some models)
CAUTION: DO NOT OPERATE THE BURNER
WITHOUT ALL BURNER PARTS AND DRIP
PANS (IF SO EQUIPPED) IN PLACE.
| Grate |
| |
| Burner | cap | |
® | Drip pan (on some models) | ||
Burner | head | ||
|
Electrode
Turn all controls off before removing burner parts and drip pans (ff so equipped).
The burner grates, caps, heads and drip pans (if so equipped) c_n be lifted off, making them easy to clean.
The | electrode | of |
|
| |
the | spark igniter | is | /// _Electrode | ||
burner | head | is |
|
| |
removed. | When | one |
|
burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around
any burner while another burner is ono An electric shock may result, which could cause you to knock over hot cookwareo
Burner Heads
(on sealed burners only)
For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A
sewing needle or wire twist tie works well to unclog it.
The sets in the burner heads of your range must be
kept dean at all times for an even, unhampered flame. You should clean the surface burners routinely, especially after bad spiltovers, which could clog these openings_
To remove
a solution of mild liquid detergent and hot water for
Before putting the burner head back, shake out
excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes°
Replace the burner caps. Make sure that caps are replaced on the correct size burner. There is one small, 2 medium and one large cap°
NOTE: On some models the caps are all the same size and can be used in any of the 4 needed locations.
Burner Caps
(on sealed burners only)
Lift offwhen cool. Wash burner caps in hot, soapy
water arid rinse with clean water° You may scour with a
plasdc scouring pad to remove
Dry them in a warm oven or with a
Medium | _ | - Large | |
Medium |
|
| |
| Front of | ran e |
|
Make sure that caps are replaced on the correct size burner_ There is one small, 2 medium and one large cap.
NOTE: On some models the caps are all the same size
27 and can be used in any of the 4 needed locations.
(continued nem page)