Sears 75375, 72671 Electrical Connections, Hectrical Requirements, Power cord of this Preferred

Installation Instructions (continued)

1.Install a manual gas line shut-offvalve in the gas line in an easily accessed location outside of the range. Make sure everyone operating the range knows where and how to shut off the gas supply to the ranger

2.Instal! male !12" flare union adapter to the I12" NPT internal thread elbow at inlet of pressure regulator,, On models equipped with standard twin burners, install the male pipe thread end of the 1t2" flare union adapter to the 1/2" NPT internal thread at inlet of' pressure regulator,, Use a back-up wrench on the regulator fitting to avoid damage.

When installing the range from the front, remove the 90 ° elbow for easier installation.

3.Install male 112" or 314" flare union adapter to the NPT internal thread of the manual shut-offvalve, taking care to back up the shut-off valve to keep it from turning.

4.Connect flexible metal appliance connector to the

adapter on the range. Position range to permit connection at the shut-offvalveo

5.When all connections have been made, make sure all range controls are in the OFF position and turn on the main gas supply valve. Use a liquid leak detector at all

joints and connections to check for leaks in the system.

C,AUTION- DO NOT USE A FLAME TO CHECK FOR GAS LEAKS.

When using test pressures greater than 1t2 psig to pressure test the gas supply system of the residence, disconnect the range and individual shut-off'valve from the gas supply piping. When using test pressures of 112 psig or less to test the gas supply system, simply isolate the range from the gas supply system by c!osing the individual shut-off valve.

STEP 3

Electrical Connections

(on some models)

Hectrical Requirements

120-volt, 60 Hertz, properly grounded branch circuit

protected by a 15-amp or 20-amp circuit breaker or

time delay fuse.

Extension Cord Cautions

Because of potential safety hazards associated with certain conditions, we strongly recommend against the use of an extension cord, However, if you still elect to use an extension cord, it is absolutely necessary that it be a Ul_-listed,3-wire grounding-type appliance extension cord and that the current carrying rating of the cord in amperes be equivalent to, or greater than, the branch circuit rating,.

Grounding--IMPORTANT (Please read carefully)

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.

The power cord of this PREFERRED ._

				METHOD		t
with a three-prong
(grounding)		plug which		__		1_
appliance is equipped
mates with		a standard
three-prong		grounding		\	II	Ensureproper
				M_. Jj)		ground exists
wa!! receptacle			to	r_		beforeuse
minimize	the		possibility
of electric	shock hazard
from this	appliance,

The customer should have the wall receptacle and circuit checked by a qualified electrician to make sure the receptacle is properly grounded.

Where a standard two-prong wall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a properly grounded three-prong walt receptacle_

DO NOT, UNDER ANY CIRCUMSTANCES, CtYF

OR REMOVE THE THIRD (GROUND) PRONG

FROM THE POWER CORD.

38