Care and Cleaning ( oo oood)
Broiler | Pan and Grid |
|
|
| ||||
After | broiling, | remove | the |
|
|
| ||
broiler pan from the oven |
|
|
| |||||
or broiler | compartment |
|
|
|
|
| ||
(depending on your model)_ | ! |
| ! | |||||
|
|
| ||||||
Remove the grid from the | ! | ! | ||||||
|
|
| ||||||
pan° | Carefillly | pour | out |
|
|
|
| |
grease | from the | pan | into | a |
| : ,,,,,7 | i | |
proper | container. | Wash | and |
|
|
|
rinse the broiler pan and grid in hot water with a
If food has burned on, sprinkle the grid with detergent while hot and cover with wet paper towels or a dishcloth.
Soaking the pan will remove
Both the broiler pan and grid can also be cleaned in a dishwasher.
Do not store a soiled broiler pan and grid anywhere in the range.
CAUTION: Do not clean the broiler pan or grid in
a
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier, protect the oven bottom from excessive spillovers by placing a cookie sheet on the shelf below tile shelf
you are cooking on. You
can use aluminum foil if
you do not cover the whole shelf. This is particularly
important when baking a fruit pie or other foods with a high acid content. Hot fruit fillings or other foods that are highly acidic (such as tomatoes, sauerkraut and sauces with vinegar or lemon juice) may cause pitting and damage to the porcelain enamel surface and should be wiped lip immediately.
To clean up spillovers, use soap and water, an abrasive cleaner or
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool. After cleaning, rinse the shelves with clean water
and dry with a clean cloth.
NOTE: Take the shelves out of the oven before you
begin the seLiLclean cycle.
Surface Light and Starter
(on some models)
CAUTION: | Do | not |
|
| |
touch | the | bulb | with | wet |
|
hands | or when | bulb | is | , Lift up | |
hot. | Never | wipe | the |
| Starter |
fight area with a wet |
|
| |||
cloth. | Electrical | power |
| ||
must be shut off ff you |
| ||||
have | to replace | a bulb. |
|
To replace the bulb:
1, With one hand at eachLight bulb end of the hinged
canopy, grasp it by the front edge and flip it up.
2.Remove the fluorescent light bulb. Replace the bulb with one of the same length and wattage.
3.Lower the canopy.
To replace the starter:
1.Open the canopy and remove the bulb as explained above_
2.Grasp the starter, turn it counterclockwise about
30 3. Replace the bulb and lower the canopy.