GE PVB98, PVB37, PVB94 Connect Control Switch to Remote Harness, Connect Wire Lead to Control Box

Installation Instructions

3 INSTALL CONTROL SWITCH (on some models)

Skip this step if there is no separate control switch.

WARNING:

Disconnect electrical power from unit before beginning switch installation. Failure to do so could result in personal injury or damage to the electrical controls.

Determine the location for the control switch. The wiring lead is 68" long.

Remote Switch

Foam Piece With Adhesive Mounting Surface

1/2"-Dia.

Hole

Strain Relief (Adhesive wire clamp with tie)

Remote Harness

Connect Control Switch to Remote Harness

•Thread the remote harness through the 1/2"-dia. hole and attach the harness connector to the remote connector.

•Remove the paper backing on the foam piece and mount the remote trim on the countertop such that the switch connectors stay located in the 1/2"-dia. hole.

•Stick adhesive wire clamp near the 1/2"-dia. hole and attach the loose wire with a wire tie.

Mating Connectors

Strain Relief (Adhesive wire clamp with tie)

Control

Box

Remote Harness

•Drill a 1/2"-dia. hole into the desired location.

Use the mounting bracket as a template to locate the hole accurately. Check for interference between the switch cover, adjacent objects

and cooktop/vent overlaps.

•If switch is mounted into a tile surface, drill the hole between tiles. Use locally approved caulking to cover any gaps.

Connect Wire Lead to Control Box

•Connect the mating wire ends.

•Place the adhesive wire clamps (provided) near the mating connector.

•Keep approximately 3"-long wire and attach the wire to the clamp with a wire tie. This will act as a strain relief.

12