GE GFB700F Before YOU Begin, Preparation, What YOU will Need, Additional Materials YOU MAY Need

Page 4

Installation Instructions

Disposer

If you have questions, call 1-800-GECARES or visit our Website at: www.GEAppliances.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.

•IMPORTANT – Save these

instructions for local inspector’s use.

•IMPORTANT – Observe all

governing codes and ordinances.

•Note to Installer – Be sure to leave these instructions with the Consumer.

•Note to Consumer – Keep these instructions for future reference.

•Skill level – Installation of this appliance requires basic mechanical skills.

•Completion time – 1 hour

•Proper installation is the responsibility of the installer.

•Product failure due to improper installation is not covered under the Warranty.

PREPARATION

1.Disconnect electrical power supply to disposer.

2.Remove old disposer or sink flange assembly.

3.Inspect drain line. If it is heavily coated with hardened grease and accumulations, rout out with a plumber’s snake.

4.Remove old sealing materials and gasketing from sink opening, both top and bottom.

NOTE: Top and bottom of sink surfaces must be free of any materials to prevent leaks.

WHAT YOU WILL NEED

•Phillips and flat blade screwdrivers

• Channel lock pliers, slip joint

• Hammer

•Nut driver

ADDITIONAL MATERIALS YOU MAY NEED

•Steel punch or wooden dowel

•Petroleum jelly or liquid soap

•Hose clamp

•Dishwasher drain connector

•Adjustable pipe wrench

•Plumber’s putty (for cast sinks)

•Stepped rubber drain adapter

•Wire nuts

•Cable connector

•Flexible drain pipe

•Power cord kit (Part Number PM3X215GDS)

4

Image 4

Contents 560C460P01 Rev. a Model # Serial #Consumer Support For Models Equipped with a Grounded CordHOW to Connect Electricity To Attach a Power CordTo Wire Your Disposer Directly into the House Current For Models Not Equipped with a CordBefore YOU Begin PreparationWhat YOU will Need Additional Materials YOU MAY NeedInstallation of Sink Flange Components and InstallationComponents Dishwasher Connection if Required Attaching the Discharge ElbowKnock OUT Plug Connect HoseConnecting Disposer to Sink Flange Attach to Sink Flange Lock Mount RingLine UP with Outlet Pipe Check for LeaksDimensions Some Typical InstallationsInstallation Instructions Instructions Troubleshooting TipsOperating instructions Continuous Feed ModelsCare and maintenance Consumer Support Troubleshooting Tips OperatingHelpful Hints InstructionsBefore you call for service… Problem Possible Causes What To DoDisposer Warranty GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYTriturador de desechos de alimentos Modelo # Serie #Servicio al consumidor Solucionar Instalación OperaciónPara modelos equipados con un cable a tierra Para modelos no equipados con un cable Solucionar problemas Servicio al consumidorPara conectar un cable eléctrico Antes DE Empezar PreparaciónQUÉ Necesita Materiales Adicionales QUE Usted Podría NecesitarComponentes E Instalación ComponentesCómo Conectar EL Codo DE Descarga Tapón DE VaciadoConecte LA Manguera Conecte EL Codo DE DescargaAlinee CON EL Tubo DE Salida Asegure EL ARO DE MontajeRevise LAS Fugas Dimensiones Algunas Instalaciones TípicasInstrucciones de operación Modelos de alimentación continuaModelos de alimentación por lote SeguridadServicio al consumidor Solucionar problemas Consejos útilesCuidado y mantenimiento Operating InstructionsAntes de llamar para solicitar servicio Problema Posibles causas Qué hacerSeguridad Instalación Garantía del Triturador Doméstico de Desechos de Alimentos Seguridad Instalación OperaciónGE reemplazará Lo que GE no cubrirá