Installation Instructions
4CONNECTING DISPOSER TO SINK FLANGE
1ATTACH TO SINK FLANGE
3LOCK MOUNT RING
Line up the disposer under the sink flange. Guide the hopper projections into the mount ring slots. Turn the mount ring about 1/4″ to the right so that the disposer is temporarily supported.
Mount
Ring Slot 
Hopper
Projection
Turn the mount ring to the right until it locks up tight. Hopper projections must be to the extreme left of the mounting slots. If the mount ring is hard to turn, you may add a small amount of petroleum jelly or liquid soap to the hopper projection. Run water and check for leaks.
2LINE UP WITH OUTLET PIPE
Turn the mount ring and the disposer until the disposer discharge elbow lines up with the outlet pipe (see page 8).
Discharge 
Elbow
Outlet Pipe 
Locking Detail
Hopper Projection in
“Supported” Position
Hopper Projection in | Mount |
“Locked” Position | Ring |
4CHECK FOR LEAKS
Check the unit for leaks 24 hours after installation and first operation.
7