Pelco FR106011 manual Installation, Package Contents, Setting the Audio Signal and Impedance Mode

Installation

PACKAGE CONTENTS

The following items are supplied:

1FT106011 transmitter or FR106011 receiver

1Regulated switching power supply with four plug adapters (North American, Australian, U.K., and European configurations); 100-240 VAC, 50-60 Hz input, 12 VDC output

11 small flat-tip screwdriver

1Wall clip with two 4-40 x 0.25-inch Phillips pan head screws with lock washers (for attachment of single module to wall)

1FT106011/FR106011 Fiber Transmitter and Receiver Installation manual (this manual)

SETTING THE AUDIO SIGNAL AND IMPEDANCE MODE

An Audio Select switch, which is a 10-position rotary switch, is provided on the bottom of the FT106011 transmitter and the FR106011 receiver (refer to Figure 5). The Audio Select switch allows you to set the desired audio mode of operation.

With the FT106011 transmitter/FR106011 receiver powered off, set the Audio Select switch to the desired mode of operation using the supplied screwdriver. Table B lists Audio Select switch settings and associated audio modes of operation as indicated on the bottom of the units.

NOTE: If you wish to change the audio mode after the FT106011 transmitter/FR106011 receiver has been powered on, power off the transmitter/receiver, change the audio mode, and then power on the transmitter/receiver again.

12 C2649M (9/07)