Installation Instructions
INSTALLING THE REFRIGERATOR (cont.)
REMOVE THE REFRIGERATOR DOORS (cont)
Note: for proper installation later, please follow the next step carefully.
FRemove the tape and keeping the door as straight as possible, open the door to 90º then lift straight up to remove it.
Lift up & off center hinge
Open Door to 90°
4REMOVE OPPOSITE DOOR
Follow the same procedure on the opposite door. There are no wires or water lines on the opposite side
REMOVE CENTER HINGE (if necessary)
Remove the 3/8ļscrews securing the center hinge to the cabinet.
Use T20 driver to remove outboard screw
Remove center screw
Loosen Outer screws
25
5 REINSTALLING THE REFRIGERATOR DOORS
Reverse steps 1 through 4 to reinstall refrigerator, follow details below for critical alignments.
A5HLQVWDOOFHQWHUKLQJHILUVWDQGWRUTXHWKHVFUHZVWR
the case, lower the refrigerator door onto the center hinge. Ensure that the door and hinge align correctly.
BRotate doors closed and make sure moveable center sealing portion of the door aligns with the striker. If the door will not
Align flats with tab.
Underside OF
Fresh Food Door
,IGRRUFDQQRWEHLQVWDOOHGDWIROORZVWHSVEHORZ
1.Install door at 180° to case front.
2.If space limits opening door to less than 180°, then:
a)Remove door, carefully turn door upside down.
b)Check alignment of door closure mechanism shaft on underside of door. The flats on the shaft should correspond to alignment tab on plastic ring or mark on bottom end cap.
c)If shaft is not aligned to tab/mark, using 5/32” Allen wrench, rotate door closure mechanism shaft counterclockwise for right door and clockwise for left door. Then align flat with tab/mark.
d)Install the door at 90°.
Securely tape the door shut with masking tape or have a second person support the door. Reinstall the top hinge
DQGWRUTXHWKHVFUHZVWRLQOEV
CBe sure to reinstall the ground wire and strain relief to the top hinge.
DReinstall hinge cover. NOTE: Ensure wires are not pinched or under screw bosses before tightening screws.