GE GE installation instructions AT-1MEASURE Cabinet Opening, Tools YOU will Need

Page 29

Installation Instructions

Anti-Tip Floor Bracket

PYE, PWE Models Only

WARNING Tip Over Hazard.

Built-in style models (model PYE, CYE, and PWE) are top heavy, especially with any doors open. These models must be secured with the anti-tip floor bracket to prevent tipping forward, which could result in death or serious injury. Read and follow the entire installation instructions for installing the anti-tip floor bracket packed with your refrigerator.

NOTE:

If you did not receive an anti-tip bracket with your purchase, call 1.800.626.8774 to receive one at no cost. (In Canada, call 1.800.561.3344.)

For installation instructions of the bracket, visit: www. GEAppliances.com.

(In Canada, www.GEAppliances.ca.)

MATERIALS YOU MAY NEED (not included)

Lag Bolts

Anchor Sleeves

1/4” (6 mm) x 1-1/2” (38 mm)

1/2” (12 mm) OD

Drill Bit Appropriate for Anchors

For Anti-Tip Bracket Mounted on CONCRETE Floors Only

AT-1MEASURE CABINET OPENING

AVAILABLE VS. REFRIGERATOR WIDTH

Measure width of cabinet opening where refrigerator will be placed, W.

Be sure to account for any countertop overhang, baseboard thickness and any clearance desired. Width, W, should not be less than 36”. The refrigerator will be placed approximately in the middle of this opening.

Rear Wall

Baseboard

 

W

Thickness or

Countertop

 

Overhang

 

(Whichever Is

 

Larger) Plus

 

Any Desired

REFRIGERATOR

Clearance

 

 

RH Side

 

Front

 

 

 

29

 

TOOLS YOU WILL NEED

1/8” (3 mm) Drill Bit and

Tape measure

Electric or Hand Drill

 

Pencil

5/16” (8 mm) Nut Driver

 

AT-2LOCATINGBRACKET THE ANTI-TIP FLOOR

APlace the anti-tip floor bracket locator template (included inside the anti-tip kit) onto the floor up against the rear wall, within W, and in line with the desired location of the RH side of the refrigerator (see Figure 1).

Figure 1 – Installation Overview

Floor – Concrete

2 Wall Holes

 

 

 

(2 Holes)

 

Floor Bracket

 

 

Floor – Wood

 

to Install

 

RH Holes

(2 Holes)

 

 

15 ¼”

 

 

 

Rear RH

 

 

Corner of

Base Bracket

RH Side of

Cabinet Wall

Locator Template

on the

Refrigerator

Sheet

Refrigerator

 

 

BPlace the anti-tip floor bracket onto the locator template with its RH floor holes lined up with the floor holes indicated on the template sheet, approximately 15 ¼” from the edge of the sheet or the RH side of the refrigerator.

CHold down in position and use the anti-tip floor bracket as a template for marking the holes based upon your configuration and type of construction as shown in Step 3. Mark the hole locations with a pencil, nail or awl.

NOTE:

‡,WLV5(48,5('WRXVHDWOHDVWVFUHZVWRPRXQW the floor bracket (one on each side of the anti-tip floor bracket). Both must be into either the wall or the floor. Figure 2 indicates all the acceptable mounting configurations for screws. Identify the screw holes on the anti-tip floor bracket for your configuration.

Refer to 239D1142P001, Pub No. 31-45484-2

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Preparing to Install Safety Instructions . . . . . . . . . . . .2GE Brillion Get Connected Select Models OnlyInstallation Proper Disposal of Your OLD Refrigerator Connecting ElectricityRefrigerants GEAppliances.comAbout the features Door ice bin Installing the filter cartridgeDrop down dairy bin Door ice/water filter Remove filter/bypass plugCubed About the controls with temperature settingsEnergy Smart GFE29, GFE27, DFE29 Control Style C, External ControlChanging the Temperature for Control Style B Changing the Temperature for Control Style aChanging the Temperature for Control Style C Changing Temp. for Control Style DAbout the controls features Ice maker setting Door Alarm Freezer temp controlControl Style C, External Controls Controls Style D, Internal Controls GNE26, PWE23About the dispenser To reinstall Dispenser TrayImportant Facts About Your Dispenser To Use the Internal Water DispenserTo Use Hands Free Auto Fill About autofillTo Stop Auto Fill Important Facts about Auto FillAbout the GE Rpwf water filter cartridge When to replace the filter cartridgeWater Filter Cartridge Removing the filter cartridgeRearranging the Shelves About the fresh food storage optionsSpillproof Shelves Quick Space ShelfAdjustable Bins on the Door Non-Adjustable Dairy BinNon-Adjustable Bins on the Door Tray openClimateZone About the climate zone Temperature controlled drawerTemperature Controlled Drawer How to Remove and Replace Drawer Divider About the climate zone and temperature controlled drawerTo remove To replaceAbout the freezer Non-Adjustable Bin in the FreezerFreezer Basket and Drawer Basket RemovalAutomatic Ice Maker About the automatic ice makerCare and cleaning of the refrigerator Refrigerator Lights LEDs Replacing the lightsTools YOU MAY Need Before YOU BeginPreparation Overall Exterior Case Width Overall Height to Top of Hinge CoverHeight to Top of Cabinet Case Depth without Doors Refrigerator Location Reinstall the handles using the same procedure as removingClearances Remove the Fresh Food Door HandleInstalling the Refrigerator Reinstalling the Refrigerator Doors Replacing the Freezer Door Remove the Freezer DoorStep Refer to 239D4144P001, Pub NoPaso 600 StepInitial position Lift by Level the Freezer DoorRemove Packaging Tools YOU will Need AT-1MEASURE Cabinet OpeningAT-4POSITIONING the Refrigerator To the House Water Line Connecting the RefrigeratorTurn on the Water Supply See the grounding information attached to the power cordPlug in the Refrigerator Level the RefrigeratorRefer to 239D4129P002 Pub No Refrigerator Assembly Instructions, suggested assemblySelect models only GE Appliances General Electric Company Louisville, KYWhat YOU will Need Installing the Water LineShut OFF the Main Water Supply ‡1/2 or adjustable wrenchChoose the Valve Location Drill the Hole for the ValveConnect the Tubing to the Valve Fasten the Shutoff ValveTighten the Pipe Clamp Route the Tubing„ On models with a dispenser, during water dispense, you may Normal operating conditionsSETTINGS, then Water FILTER. Select Before you call for service…Non-LCD models LCD modelsAuto Fill overfills Troubleshooting TipsCheck that the ice maker is turned on. See Freezer cooling, fresh food not coolingRefrigerator control panel to ensure the door alarm is on ReplacementWhen the refrigerator is installed, or after replac Avoid odor and taste problemsAccess to final location Door removal is always required for installationCan be adjusted to close properly There is an adjustment to rear wheelsRefer to 239D3392P001 Pub No GET ConnectedWhat GE Will Not Cover Improper installation, delivery or maintenanceLoss of food due to spoilage Damage caused after deliveryRpwf Water Filter Cartridge Limited Warranty Performance Data Sheet Model GE Rpwf Water Treatment Device Certificate Number Consumer Support Schedule Service
Related manuals
Manual 48 pages 27.25 Kb Manual 3 pages 9.92 Kb

GE specifications

General Electric, commonly referred to as GE, is a global conglomerate with a diverse portfolio that encompasses several industries including aviation, healthcare, power, renewable energy, and manufacturing. Founded in 1892, GE has established itself as a leader in technology and innovation, driven by a commitment to deliver cutting-edge solutions that address the world’s most pressing challenges.

One of the hallmark features of GE is its strong emphasis on research and development. The company invests billions of dollars each year in R&D, fostering innovation across its various business sectors. This focus on technological advancement has resulted in a myriad of breakthroughs, such as GE's development of advanced jet engines that significantly improve fuel efficiency and reduce emissions, setting new standards in the aviation industry.

In healthcare, GE has revolutionized medical imaging and diagnostic technologies. With products such as MRI machines and ultrasound equipment, GE has led the way in providing high-quality imaging solutions that enhance patient care. The company’s digital healthcare technologies leverage artificial intelligence to improve diagnostics and streamline operations for healthcare providers, ultimately enhancing patient outcomes.

In the energy sector, GE is at the forefront of the shift toward renewable energy. The company develops wind turbines, gas turbines, and energy storage solutions that integrate with traditional power sources to create a more sustainable energy landscape. GE’s commitment to reducing carbon emissions is evident in its innovative technologies that harness the power of wind, solar, and hydroelectric energy.

GE’s digital industrial transformation is another defining characteristic, as it integrates the Internet of Things (IoT) into its operations and product offerings. Through the use of advanced data analytics and machine learning, GE is creating smart and connected solutions that enhance operational efficiency and predictive maintenance across industries.

The company's global presence and commitment to sustainability also contribute to its reputation as a responsible corporate citizen. GE has implemented initiatives to reduce its environmental footprint and improve community engagement around the world.

In summary, General Electric’s main features include its strong focus on R&D, revolutionary healthcare technologies, leadership in renewable energy, digital industrial transformation, and a commitment to sustainability. With a rich history and a forward-looking approach, GE continues to shape industries and improve lives through innovation.
Top Page Image Contents