GE JGP990 manual Care and cleaning of the cooktop, Before Cleaning, Grease Jar, Porcelain Cooktop

Page 15

Care and cleaning of the cooktop.

ge.com

Before Cleaning

 

Before cleaning any part of your

cooktop power plug, located beneath

cooktop, be sure all controls are off

the cooktop and inside the cabinets.

and DISCONNECT ELECTRICAL POWER

Do not operate the cooktop without all

TO THE COOKTOP at the fuse box or

parts in place.

circuit breaker panel, or pull the

 

Safety Instructions

Control Knobs and Control Panel Seal

After grilling there may be soot on the knobs and control panel seal. This soot can be removed by scrubbing with a plastic scrubber and mild dishwashing detergent. The control knobs may

be removed for cleaning.

To remove a knob, pull it straight up.

Wash the knobs in soap and water but do not soak. Avoid getting water down into the knob stem holes.

Wipe with a sponge, damp cloth or paper towel. Do not scrub with steel wool pads or abrasive cleansers.

To replace a knob, match the flat part of the knob opening with the flat side of the shaft.

Operating Instructions

Grease Jar

A grease jar is located below the grill

If the jar is broken, replace with any

basin pan under the countertop. Check

heat tempered jar, such as a canning

periodically to prevent spillovers.

jar, that has a wide mouth screw neck.

Unscrew and remove.

 

 

 

Porcelain Cooktop

 

Care and

The porcelain enamel finish is sturdy but breakable if misused. This finish is acid-resistant. However, any acidic foods spilled (such as fruit juices, tomato or vinegar) should not be permitted to remain on the finish.

If acids spill on the cooktop while it is hot, use a dry paper towel to wipe it up right away. When the surface has cooled, wash with soap and water or cleansing powders. Rinse well.

For other spills, such as fat spatterings, wash with soap and water or cleansing powders after the surface has cooled. Rinse well. Polish with a dry cloth.

Cleaning Troubleshooting

Stainless Steel Surfaces

Do not use a steel wool pad; it will scratch the surface.

To clean the stainless steel surface, use warm sudsy water or a stainless steel cleaner or polish. Always wipe the surface in the direction of the grain. Follow the cleaner instructions for cleaning the stainless steel surface.

To inquire about purchasing stainless steel appliance cleaner or polish, or to find the location of a dealer nearest you, please call our toll-free number:

National Parts Center

800.626.2002

ge.com

15

Tips Consumer Support

Image 15
Contents Write the model and serial numbers here Model # Serial # InstallationWhat to do if YOU Smell GAS Ge.com Important Safety NoticeCook Meat and Poultry THOROUGHLY… Surface Burners Feature Index Features of your cooktopGriddle Model JXGL90L Cooktop accessoriesGrill Model JXGG90L Sealed Burner ModuleBefore Lighting a Gas Burner Using the gas surface burnersHow to Select Flame Size Electric IgnitionWok This Way Using your cooktopUsing the downdraft vent system How to Operate the Downdraft Vent SystemGrill Module Surface burner and grill modulesUsing the Grill GrillingShould a Sustained Flare-Up Occur Grilling Tips Grilling guide Type Control Setting Cooking Time ProcedureGriddle Guide Griddle AccessoryUsing the griddle GriddlePorcelain Cooktop Care and cleaning of the cooktopBefore Cleaning Grease JarGrill Burner Grill GrateVent Grille and Filter Porcelain Burner Basin IgnitersRead these instructions completely and carefully Installation InstructionsParts Included Unpack Your CooktopTools and Parts Needed Preparing for InstallationFor flexible connection where local codes permit PreparationMinimum Spacing Requirement Installing Cabinets Over Your CooktopProvide Adequate GAS Supply Pressure TestingPreparing the Countertop GAS and Electrical LocationPrepare for Ductwork Blower to Ductwork AlignmentTypical duct arrangement countertop series Install the Ductwork Plan the Duct RUNGeneral Considerations Ductwork Calculations Should not exceed 100 feet equivalent lengthDo not use flexible plastic ducting Prepare the Cooktop Install the CooktopInstall the Pressure Regulator and Connect Test for LeaksPerform leak test per the following instructions Connect the Ductwork Install the CooktopSecure the Cooktop Optional Attach a Blower Transition DuctCheck Operation of Downdraft Final AssemblyInstall Grease JAR, Downdraft Filter and Vent Grille Assemble the CooktopTools YOU will Need LP Conversion Instructions Gas CooktopGAS Supply Adjust Grill Burner AIR Shutter Convert Surface BurnersCheck Ignition Flame Recheck Testing Flame StabilityProblem Possible Causes What To Do Before you call for service…Large or yellow OccasionalSparking sound Burner flames veryCare and Cleaning We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Warrantor General Electric Company. Louisville, KY GE Gas Cooktop WarrantyGE Will Replace What GE Will Not CoverReal Life Design Studio Schedule ServiceParts and Accessories Consumer Support GE Appliances WebsiteEscriba aqui el modelo y números de serie Modelo No Serie No Manual del propietario e Instrucciones de Instalación¡ADVERTENCIA Precaucion No deberán Aviso Importante DE SeguridadInstrucciones Importantes DE Seguridad Advertencia Indice de las características Características de su estufa de cubiertaPlancha Modelo JXGL90L Asador Modelo JXGG90LDespués de encender un quemador Cómo usar los quemadores de la superficieIgnición eléctrica Cómo encender un quemadorCacerolas para cocinar Como usar su estufa de cubiertaEl sistema de ventilación Cocinar en ollas tipo wokMódulo de quemadores sellados Módulos de quemadores y de asadorCómo utilizar el asador Para asarConsejos para asar Guía para asar TipoTiempo de cocción Procedimiento Plancha para asar La plancha para asarGuía de la plancha para asar Cuidado y limpieza Quemador del asador Parrilla del asadorRejilla y filtro de ventilación Apoyo al consumidor IgnitoresMódulo de quemador sellado Contenedor de porcelana de los quemadoresLea estas instrucciones completa y cuidadosamente Instrucciones de instalaciónPartes Incluidas Desempaque LA EstufaPara conexiones rígidas PreparaciónHerramientas Y Partes Necesarias ImportanteEspacio Mínimo Requerido Cómo Probar LA Presión Preparación DE LA EncimeraUbicación DEL Suministro Eléctrico Y DE GAS Proporcione EL Suministro Adecuado DE GASPreparacion Para EL Ducto Alineación DE LOS Conductos DEL SopladorNota Consideraciones Generales Instalación DEL ConductoCálculos DE LOS Ductos ImportanteNo USE conductos plásticos flexibles Prepare LA Estufa Instalación DE LA EstufaPruebe Para Fugas Instalación Y Conexión DELConecte LOS Conductos Instale LA EstufaAsegure LA Estufa DEL SopladorInspeccione LA Operación DE Ventilación Descendente Ensamblaje FinalEnsamble LA Estufa DE Ventilación Descendente LA Rejilla DE VentilaciónHerramientas QUE Necesitará Instrucciones de conversión a LPConvierta EL Regulador DE Presión Suministro DE GASAjuste EL Obturador DE Aire Para EL Quemador DEL Asador Convierta LOS Quemadores DE SuperficieInspeccione LA Ignición Ajuste LA Llama Baja Para Hervir a Fuego LentoLlama Para Inspeccionar SI Existen Fugas Cómo Convertir Otra VEZ a GAS Natural Cómo probar la estabilidad de la llamaReinspección de la llama Antes de llamar para solicitar servicio… Problema Causas posibles Qué hacerQuemador Sonido ocasional de El sonido de chispaPersiste después de Haber apagado elVentilación deficiente El ventilador noFunciona AutomáticamenteNotas Garante General Electric Company. Louisville, KY Garantía de GE para su estufa de cubierta a gasGE reemplazará Lo que no está cubierto por GEPiezas y accesorios Apoyo al consumidor Página Web de GE AppliancesSolicite una reparación Garantías ampliadas

JGP990 specifications

The GE JGP990 is a high-performance gas range that stands out for its innovative features, robust construction, and impressive cooking capabilities. As part of General Electric's profile line, the JGP990 reflects the brand's legacy of quality and reliability while incorporating modern technologies that cater to the needs of today's home cooks.

At the forefront of the JGP990's features is its five-burner cooking surface, which includes a powerful 21,000 BTU tri-ring burner. This burner allows for versatile cooking techniques, from rapid boiling to gentle simmering. With multiple burner sizes, users can easily adjust the heat to accommodate various pot sizes and cooking methods. Furthermore, the continuous grates provide a seamless surface that allows for easy movement of pots and pans across the burners, enhancing convenience and efficiency.

In addition to its impressive burner options, the GE JGP990 is equipped with a built-in electric ignition system, providing reliable and easy start-up. This system eliminates the need for matches or lighters, allowing for a hassle-free cooking experience. The range also features heavy-duty cast iron grates that are not only durable but also add an element of professional-grade quality to the kitchen.

One of the standout features of the GE JGP990 is its integrated oven, which utilizes a powerful convection cooking system. This technology ensures even heat distribution, resulting in perfectly cooked meals, whether baking or roasting. The oven's self-cleaning mode simplifies maintenance, allowing users to spend less time scrubbing and more time enjoying their culinary creations.

The design of the JGP990 is equally impressive, available in stylish finishes that fit seamlessly into contemporary kitchens. The sleek stainless steel exterior not only enhances the aesthetic appeal but is also easy to clean, making it perfect for busy households.

Safety is paramount in the design of the GE JGP990, which includes features such as control lock and automatic shut-off. These elements provide peace of mind, especially for families with children.

Overall, the GE JGP990 gas range is a harmonious blend of power, versatility, and style, making it an ideal choice for both amateur cooks and professional chefs alike. Its cutting-edge features, reliable performance, and thoughtful design position it as a standout appliance in the ever-evolving culinary landscape.