GE JGP990 manual Install the Pressure Regulator and Connect, Test for Leaks

Page 27

Installation Instructions

INSTALL THE COOKTOP

10PREPARE THE COOKTOP (cont.)

Remove the blank 9-pin connector plug from the

9-pin receptacle on the bottom of the cooktop and discard. Connect the 9-pin plug on the blower assembly to the matching 9-pin receptacle on the bottom of the cooktop. Secure the connector cover to the cooktop using 3 screws, making sure the power cord comes out the U-shaped opening with the wires to the motor.

9-pin

 

connectors

Connector

 

 

cover

11INSTALL THE PRESSURE REGULATOR AND CONNECT

Regulator

Solid piping or flexible connector

Union

Solid piping

or flexible connector

Shut-off valve

Pipe stub

Using pipe sealant, approved by local codes, install the supplied pressure regulator in the gas line as close to the cooktop inlet as possible. Allowances for ventilation ducting may be necessary.

Do not route the gas line under the access box under the cooktop. Allow room for removal of the connector panel for servicing.

Make sure the regulator is installed in the proper direction.

Install a manual shut-off valve in the gas line in an easily accessible location.

11INSTALL THE PRESSURE

REGULATOR AND CONNECT

(cont.)

NOTE: Instead of using solid piping to connect to the pressure regulator, an approved flexible metal appliance connector may be used between the shut-off valve and the pressure regulator, if local codes permit.

Appropriate flare nuts and adapters are required at each end of the flexible connector.

Make sure all the knobs are in the off position. Hook up the gas line and check for leaks.

TEST FOR LEAKS

WARNING: DO NOT USE A FLAME TO CHECK FOR GAS LEAKS! Do not use the cooktop until all connections have been leak tested.

Perform leak test per the following instructions:

1.Purchase a liquid leak detector or prepare a soap solution of one part water, one part liquid detergent.

2.When all connections have been made, make sure all cooktop controls are turned to OFF and turn the gas supply valve to ON.

3.Apply the liquid leak detector or the soap solution around all connections from the shut-off valve to the cooktop.

4.A leak is identified by a flow of bubbles from the area of the leak.

5.If a leak is detected, turn the gas supply off. Tighten the fitting. Turn the gas on and test again.

1.If the leak persists, turn the gas supply off and contact your dealer for assistance. Do not attempt to operate the cooktop if a leak is present.

IMPORTANT: Disconnect the cooktop and the individual shut-off valve from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig. Isolate the cooktop from the gas supply piping system by closing the individual manual shut-off valve to the cooktop during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Write the model and serial numbers here Model # Serial # InstallationWhat to do if YOU Smell GAS Ge.com Important Safety NoticeCook Meat and Poultry THOROUGHLY… Surface Burners Feature Index Features of your cooktopGriddle Model JXGL90L Cooktop accessoriesGrill Model JXGG90L Sealed Burner ModuleBefore Lighting a Gas Burner Using the gas surface burnersHow to Select Flame Size Electric IgnitionWok This Way Using your cooktopUsing the downdraft vent system How to Operate the Downdraft Vent SystemGrill Module Surface burner and grill modulesUsing the Grill GrillingShould a Sustained Flare-Up Occur Grilling Tips Grilling guide Type Control Setting Cooking Time ProcedureGriddle Guide Griddle AccessoryUsing the griddle GriddlePorcelain Cooktop Care and cleaning of the cooktopBefore Cleaning Grease JarGrill Burner Grill GrateVent Grille and Filter Porcelain Burner Basin IgnitersRead these instructions completely and carefully Installation InstructionsParts Included Unpack Your CooktopTools and Parts Needed Preparing for InstallationFor flexible connection where local codes permit PreparationMinimum Spacing Requirement Installing Cabinets Over Your CooktopProvide Adequate GAS Supply Pressure TestingPreparing the Countertop GAS and Electrical LocationPrepare for Ductwork Blower to Ductwork AlignmentTypical duct arrangement countertop series Install the Ductwork Plan the Duct RUNGeneral Considerations Ductwork Calculations Should not exceed 100 feet equivalent lengthDo not use flexible plastic ducting Prepare the Cooktop Install the CooktopInstall the Pressure Regulator and Connect Test for LeaksPerform leak test per the following instructions Connect the Ductwork Install the CooktopSecure the Cooktop Optional Attach a Blower Transition DuctCheck Operation of Downdraft Final AssemblyInstall Grease JAR, Downdraft Filter and Vent Grille Assemble the CooktopTools YOU will Need LP Conversion Instructions Gas CooktopGAS Supply Adjust Grill Burner AIR Shutter Convert Surface BurnersCheck Ignition Flame Recheck Testing Flame StabilityProblem Possible Causes What To Do Before you call for service…Large or yellow OccasionalSparking sound Burner flames veryCare and Cleaning We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Warrantor General Electric Company. Louisville, KY GE Gas Cooktop WarrantyGE Will Replace What GE Will Not CoverReal Life Design Studio Schedule ServiceParts and Accessories Consumer Support GE Appliances WebsiteEscriba aqui el modelo y números de serie Modelo No Serie No Manual del propietario e Instrucciones de Instalación¡ADVERTENCIA Precaucion No deberán Aviso Importante DE SeguridadInstrucciones Importantes DE Seguridad Advertencia Indice de las características Características de su estufa de cubiertaPlancha Modelo JXGL90L Asador Modelo JXGG90LDespués de encender un quemador Cómo usar los quemadores de la superficieIgnición eléctrica Cómo encender un quemadorCacerolas para cocinar Como usar su estufa de cubiertaEl sistema de ventilación Cocinar en ollas tipo wokMódulo de quemadores sellados Módulos de quemadores y de asadorCómo utilizar el asador Para asarConsejos para asar Guía para asar TipoTiempo de cocción Procedimiento Plancha para asar La plancha para asarGuía de la plancha para asar Cuidado y limpieza Quemador del asador Parrilla del asadorRejilla y filtro de ventilación Apoyo al consumidor IgnitoresMódulo de quemador sellado Contenedor de porcelana de los quemadoresLea estas instrucciones completa y cuidadosamente Instrucciones de instalaciónPartes Incluidas Desempaque LA EstufaPara conexiones rígidas PreparaciónHerramientas Y Partes Necesarias ImportanteEspacio Mínimo Requerido Cómo Probar LA Presión Preparación DE LA EncimeraUbicación DEL Suministro Eléctrico Y DE GAS Proporcione EL Suministro Adecuado DE GASPreparacion Para EL Ducto Alineación DE LOS Conductos DEL SopladorNota Consideraciones Generales Instalación DEL ConductoCálculos DE LOS Ductos ImportanteNo USE conductos plásticos flexibles Prepare LA Estufa Instalación DE LA EstufaPruebe Para Fugas Instalación Y Conexión DELConecte LOS Conductos Instale LA EstufaAsegure LA Estufa DEL SopladorInspeccione LA Operación DE Ventilación Descendente Ensamblaje FinalEnsamble LA Estufa DE Ventilación Descendente LA Rejilla DE VentilaciónHerramientas QUE Necesitará Instrucciones de conversión a LPConvierta EL Regulador DE Presión Suministro DE GASAjuste EL Obturador DE Aire Para EL Quemador DEL Asador Convierta LOS Quemadores DE SuperficieInspeccione LA Ignición Ajuste LA Llama Baja Para Hervir a Fuego LentoLlama Para Inspeccionar SI Existen Fugas Cómo Convertir Otra VEZ a GAS Natural Cómo probar la estabilidad de la llamaReinspección de la llama Antes de llamar para solicitar servicio… Problema Causas posibles Qué hacerQuemador Sonido ocasional de El sonido de chispaPersiste después de Haber apagado elVentilación deficiente El ventilador noFunciona AutomáticamenteNotas Garante General Electric Company. Louisville, KY Garantía de GE para su estufa de cubierta a gasGE reemplazará Lo que no está cubierto por GEPiezas y accesorios Apoyo al consumidor Página Web de GE AppliancesSolicite una reparación Garantías ampliadas

JGP990 specifications

The GE JGP990 is a high-performance gas range that stands out for its innovative features, robust construction, and impressive cooking capabilities. As part of General Electric's profile line, the JGP990 reflects the brand's legacy of quality and reliability while incorporating modern technologies that cater to the needs of today's home cooks.

At the forefront of the JGP990's features is its five-burner cooking surface, which includes a powerful 21,000 BTU tri-ring burner. This burner allows for versatile cooking techniques, from rapid boiling to gentle simmering. With multiple burner sizes, users can easily adjust the heat to accommodate various pot sizes and cooking methods. Furthermore, the continuous grates provide a seamless surface that allows for easy movement of pots and pans across the burners, enhancing convenience and efficiency.

In addition to its impressive burner options, the GE JGP990 is equipped with a built-in electric ignition system, providing reliable and easy start-up. This system eliminates the need for matches or lighters, allowing for a hassle-free cooking experience. The range also features heavy-duty cast iron grates that are not only durable but also add an element of professional-grade quality to the kitchen.

One of the standout features of the GE JGP990 is its integrated oven, which utilizes a powerful convection cooking system. This technology ensures even heat distribution, resulting in perfectly cooked meals, whether baking or roasting. The oven's self-cleaning mode simplifies maintenance, allowing users to spend less time scrubbing and more time enjoying their culinary creations.

The design of the JGP990 is equally impressive, available in stylish finishes that fit seamlessly into contemporary kitchens. The sleek stainless steel exterior not only enhances the aesthetic appeal but is also easy to clean, making it perfect for busy households.

Safety is paramount in the design of the GE JGP990, which includes features such as control lock and automatic shut-off. These elements provide peace of mind, especially for families with children.

Overall, the GE JGP990 gas range is a harmonious blend of power, versatility, and style, making it an ideal choice for both amateur cooks and professional chefs alike. Its cutting-edge features, reliable performance, and thoughtful design position it as a standout appliance in the ever-evolving culinary landscape.
Top Page Image Contents