Installation Instructions
LOCATION OF YOUR WASHER
Do Not Install the Washer:
1.In an area exposed to dripping water or outside weather conditions. The ambient temperature should never be below 60°F (15.6°C) for proper washer operation.
2.In an area where it will come in contact with curtains or drapes.
3.On carpet. The floor MUST be a hard surface with a maximum slope of 1/2″ per foot (1.27 cm per
30 cm). To make sure the washer does not vibrate or move, you may have to reinforce the floor.
NOTE: If floor is in poor condition, use 3/4″ impregnated plywood sheet solidly attached to the existing floor covering.
IMPORTANT:
Minimum Installation Clearances
•When installed in alcove: Sides, Rear, Top = 0″ (0 cm)
•When installed in closet: Sides, Rear, Top = 0″ (0 cm), Front = 1″ (2.54 cm)
•Closet door ventilation openings required:
2 louvers each 60 square in. (387 cm2), located 3″ (7.6 cm) from top and bottom of door
ROUGH-IN DIMENSIONS
FRONT
27” (68.58 cm)
39.8” (101.1 cm)
SIDE | cm) |
|
(2.1 |
| |
|
| |
34” (86.36 cm) | 0.83” |
|
|
| |
| 39” (99.06 cm) | 39.8” (101.1 cm) |
*NOTE:
With Washer Legs: 40.5” (102.5 cm) (0.75” adjustability)
With Pedestal: 53.75” (136.6 cm) (0.75” adjustability)
Stacked: 82.75” (209.8 cm)
15