Maytag MFI2568AEW manual View looking down from the top Ice/water dispenser

Page 6

8.Have your helper hold the frame while you unplug the small wire connector (Fig 2) from the PCB. This will stop the power from going to the door flapper and ice dispenser.

View looking down from the top

of the ice/water dispenser

Power to flapper door and water dispenser

© 2007 Stephen Beck

Fig. 2

9.Re-assemble the front door frame by hooking it to the top and gently pressing it back into place.

10.Replace the 2 screws to keep it from popping off.

11.Replace the drip tray

12.Plug the fridge back in. If the ice door flapper is in the open position, stick a CLEAN (white preferred, color choice your decision) sock into the opening to prevent cold air from escaping.

© 2007 by Stephen Beck V1.0

Page 6 of 19

Use at your Own Risk

Image 6

Contents MFI2568AEW Important Safety Reminders and Legal Stuff Don’t Skip Overview Technical stuffParts and Supplies List Step-By-Step procedures Unplug the fridgePower to flapper door and water dispenser View looking down from the top Ice/water dispenserFixing the HV Control Board Remove the PCB from the fridgeOne good cap Release Clip. All 4 connectors similar By Stephen Beck Use at your Own Risk Positive Terminal Negative Replace the CapsMinus signs Negative Terminals Minus Signs Negative TerminalMinus Sign Minus Signs Caps Plus signs on PCB By Stephen Beck Use at your Own Risk Re-install the PCB By Stephen Beck Use at your Own Risk Testing the Fridge Caution Required Optional Plug the flapper door back View looking down from the top Ice/water dispenser