Release Clip. All 4 connectors similar

10.Understand there are 4 wire connectors plugged into the circuit board that will need to be removed. They are all removed in the same manner. You will want to either mark or draw a picture as to which connector comes from what plug to make re-assembly easier. The wires are just the right lengths and naturally fit to the proper connectors if you want to skip the pictures/labels. See Fig 7:

Behind

the

label

Fig. 7

11.GENTLY depress the top of the lever in the middle of one of the connectors and pull the connector up off of the PCB. You may have to GENTLY rock the connector back and forth (along the long side) to get the connector off. (Fig. 8)

Fig. 8

12.Repeat the above step for the rest of the connectors.

13.Understand that the PCB is held in place by a top and bottom plastic clips that can break, and the right side tucks into a slot in the white plastic tub holding the PCB and wires. (Fig 9).

PCB hold-down clips

Fig. 9

Page 9 of 19

Use at your Own Risk