Plumbing
Once the hood is hung, the recirculation pump and detergent tank (both shipped loose) must be installed in the controls cabinet.
Pump Installation
•Remove bolts from pump mounting plate in cabinet.
•Place the pump on the isolators located on the mounting plate with the bolts removed.
•Secure the pump to the mounting plate with the four previously removed bolts.
•Wire pump motor to the control cabinet per wiring diagram on the cabinet.
•The wires to power the motor are already connected to the pump motor. It only needs to be wired to the control cabinet.
Position pump on
(4)isolators and attach using provided nuts.
Connect to control |
|
cabinet per |
|
Wiring Diagram |
|
in panel |
|
| Field |
connect | |
Connect to drain | |
| unions |
Plumbing Connections
A
E
A
DB
C 
A.
B.Detergent tank
C.Mounting plate
D.Isolators (qty of four)
E.Detergent pump
1.Connect the inlet and outlet piping on the recirculation pump to the respective piping in the cabinet via the threaded 1 in. unions.
2.Bring the inlet water piping to the connection located on the top of the hood and connect to the threaded connection on the 3/4 in. solenoid valve. A ball valve needs to be placed in the connection line before the 3/4 in. solenoid valve. Depending on water pressure, the inlet valve might need to be closed slightly to reduce water pressure. Water temperature should be 140°F.
Inlet Solenoid
Connection
3.Bring the drain piping connection to the 1 in. solenoid valve in the control cabinet and connect to the threaded connection. This is a pressurized drain system and needs a properly sized drain to accommodate the pressurized drain water.
NOTE
As the suggested detergent is
16 Model GGH2O
®