Maytag 12828186A Water and Ice Dispenser, Removing and Replacing Ice Storage Bin, Remember

Page 11

Removing and Replacing Ice Storage Bin

To Remove the Ice Storage Bin:

1.Hold the base of the storage bin and press the release button on the lower right.

2.Pull the storage bin out until resistance is felt. Lift up the front of the ice bin and remove.

3.Press the switch to the OFF position

To Replace the Ice Storage Bin:

IMPORTANT: It may be necessary to turn the auger driver, behind the ice bin, counterclockwise to properly align the ice bin with the auger driver. The ice storage bin must be locked in place for proper ice dispensing.

1.Press the switch to the ON position

2.Slide the ice bin into the guide rails located on either side of the enclosure.

3.Push the ice bin in until resistance is felt. Raise the front slightly and push the ice bin in until an audible “click” is heard.

A

Water and Ice Dispenser

IMPORTANT:

After connecting the refrigerator to a water source, flush the water system. Press the Water button on the control panel. Use a sturdy container to depress and hold the dispenser lever for 5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever

(5 seconds on, 5 seconds off) for an additional 2 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.

NOTE: After five minutes of continuous dispensing, the dispenser will stop dispensing water to avoid flooding. To continue dispensing, remove the container and press the dispensing lever again.

Allow 24 hours for the refrigerator to cool down and chill water. Dispense enough water every week to maintain a fresh supply.

The dispenser will dispense either water or cubed ice.

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

B

A. ON position

B. Auger driver

Ice Production Rate

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

The ice maker should produce approximately 8 to 12 batches of ice in a 24-hour period.

To increase ice production, lower the freezer and refrigerator temperature. See “Using the Controls.” Wait 24 hours between adjustments.

Dispense Ice and Water

WARNING

Cut Hazard

Use a sturdy glass when dispensing ice.

Failure to do so can result in cuts.

1.Select water or cubed ice by touching the word “water” or “ice” on the control panel. The light above the control indicates your selection.

Remember

The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.

Do not use anything sharp to break up the ice in the bin. This can cause damage to the ice bin and dispenser mechanism.

Do not store anything on top of the ice maker or in the ice storage bin.

2.Press a sturdy container against the dispenser lever.

IMPORTANT: You do not need to apply a lot of pressure to the lever in order to activate the dispenser. Pressing hard will not make the water or ice dispense faster or in greater quantities.

3.Remove the container to stop dispensing.

11

Image 11
Contents Refrigerator User Instructions Refrigerator SafetyBefore You Throw Away Your Old Refrigerator or Freezer Installation InstructionsClean Before Using Unpack the RefrigeratorRecommended Grounding Method Location RequirementsElectrical Requirements Water Supply RequirementsConnect to Water Line Connect the Water SupplyWater Pressure Reverse Osmosis Water SupplyStyle 2 Plastic Handles Complete the InstallationRefrigerator Doors and Drawer Remove and Replace Handles Style 1 Metal HandlesReplace Drawer Front Replace Doors and HingesRemove and Replace Freezer Drawer Remove Drawer FrontDrawer Front Removal Drawer Front Replacement Style 1 Front and rear leveling Adjust the DoorsRefrigerator USE Opening and Closing DoorsUsing the Controls Ice Maker and Ice Storage Bin Crisper Humidity ControlDispense Ice and Water Water and Ice DispenserRemoving and Replacing Ice Storage Bin Ice Production RateWater Filtration System CleaningRefrigerator Care Refrigerator will not operate TroubleshootingChanging the Light Bulb Refrigerator OperationIce and Water Temperature and MoistureWater is leaking from the dispenser system Water Filter CertificationsOff-taste, odor or gray color in the ice Water and ice dispenser will not operate properlyApplication Guidelines/Water Supply Parameters Product Data SheetsThis limited warranty does not cover Maytag Major Appliance WarrantyLimited Warranty Items Excluded from WarrantySécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurEnlèvement des matériaux d’emballage Instructions D’INSTALLATIONDéballage du réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurSpécifications de l’alimentation en eau Exigences demplacementMéthode recommandée de mise à la terre Spécifications électriquesRaccordement au réfrigérateur Pression de leauAlimentation en eau par osmose inverse Raccordement à une canalisation d’eauEnlèvement de la porte et des charnières Achever l’installationPortes et tiroir du réfrigérateur Style 2 Poignées en plastiqueEnlèvement de la façade du tiroir Réinstallation des portes et des charnièresRetirer et réinstaller le tiroir du congélateur Réinstallation de la façade du tiroirEnlèvement et réinstallation de la porte Style 1-Nivellement avant et arrière Utilisation DU RéfrigérateurAjustement des portes Ouverture et fermeture des portesDésactivation/activation du réfrigérateur Utilisation des commandesCommandes de température Ajustement des commandesReset Filter réinitialisation du filtre Humidity Control commande dhumidité sur certains modèlesTemp Alarm alarme de dépassement de température Door Alarm avertisseur de la porteTaux de production de glaçons Dépose et réinstallation du bac d’entreposage à glaçonsDistributeur d’eau et de glaçons Mise en marche/arrêt de la machine à glaçonsSystème de filtration de leau Nettoyage de votre réfrigérateur Remplacement de l’ampoule d’éclairageEntretien DU Réfrigérateur NettoyageFonctionnement du réfrigérateur DépannageIl y a une accumulation dhumidité à lintérieur Température et humiditéGlaçons et eau La température est trop élevéeLeau du distributeur est tiède Système de filtration d’eau intérieur Feuilles DE Données SUR LE ProduitLa présente garantie limitée ne couvre pas Garantie LimitéeArticles Exclus DE LA Garantie Tous droits réservés 12828186A SP PN 12828190A