Safety & Warnings
WARNING
Cut Hazard
Beware of sharp edges when handling stainless steel appliances.
Failure to use caution could result in injury or cuts.
WARNINGS!
Particular attention shall be given to the relevant requirements regarding ventilation.
This product should not be sealed into the bench with silicone or glue. Doing so will make future servicing difficult.
Fisher & Paykel will not be liable for costs associated with releasing such a product, nor for repairing damage that may be incurred in doing this.
When this product is installed it shall not be used as a space heater, especially if installed in boats or caravans.
No combustible material or products should be placed on this product at any time.
Do not spray aerosols in the vicinity of this product while it is in operation.
CAUTION!
This product must be installed according to these installation instructions and must comply with local building regulations, local gas authority codes and electrical regulations.
Failure to install the product correctly could invalidate any warranty or liability claims.
IMPORTANT!
Read these instructions carefully before installing or using this product.
Please make this information available to the person responsible for installing the product as it could reduce your installation costs.
These products are registered:
in New Zealand at www.ess.govt.nz and in Australia with AGA at www.gas.asn.au.
Before You Start
Prior to installation, ensure that the local distribution conditions (nature of gas and pressure) and the adjustment of the product are compatible. For adjustment conditions for this product see Gas Rate Summary.
This gas hob must be connected to a 220V - 240V 50Hz power supply only and must be earthed via the power cord.
Ensure a suitable disconnection switch is incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. A means of disconnection with at least a
3 mm air gap contact separation in all poles must be incorporated into the fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for alternative means.
Ensure that there is a power outlet within reach of the cooktop cable (900 mm from the rear right of the product). This must be accessible after installation. The mains cable should not touch any metal parts.
Make the bench top of a heat resistant material.
Seal exposed bare edges of the cutout with an
2