Fisher & Paykel DD602I manual Trimming the TOE Kick Pins, DD13

IMPORTANT

Before cutting the Lower Toe Kick, ensure the Toe Kick is positioned on a wooden chopping board to avoid damage to surrounding area.

IMPORTANT

Ensure the Toe Kick Pins are positioned on a wooden chopping board to avoid damage to surrounding area.

4.2.2

To establish which groove to trim along, measure the Toe Kick against both sides of the product, allowing a minimum gap of 3/32” (2.5mm) between the Upper and Lower Toe Kicks.

Neatly cut through the vertical ribs of the Toe Kick and trim along the full length of the groove.

4.2.3

Bend the cut edges apart slightly and carefully cut through from the front.

4.2.4

Sand the edges to remove any rough patches.

STEP 4.3 TRIMMING THE TOE KICK PINS

4.3.1

Mark the Toe Kick Pins against the trimmed Lower Toe Kick.

NOTE: DO NOT insert the Pins into the Kick before cutting to length.

4.3.2

Place the Toe Kick Pin onto a wooden chopping board and trim the Pin by cutting down the corresponding groove to the trimmed Lower Toe Kick. Cut the outer edges of the Toe Kick Pins from the inside to the outside.

Page DD_13