Fisher & Paykel DD602I manual Final Checks, Installation WET Test, Troubleshooting, DD23

SECTION 8

Page DD_23

FINAL CHECKS

STEP 8.1 INSTALLATION WET TEST

1. Ensure product is level, securely fastened to the floor and opens and closes freely.

2.	Ensure inlet hose to faucet connection is tightened to specification.
3.	Ensure any knockouts or plugs in drain connection have been drilled out
	and drain connection made to specification.
4.	Plug in and turn ON the power and water supply. The DishDrawer should
5.	"beep" and light up.
	Open the drawers of the DishDrawer and check operation of Secondary
6.	Control Panel and check sprayarm(s) are in place and free to rotate.
	Select Rinse program on the Secondary Control Panel and close the
7.	drawers.
	Start the Program by pressing the Start/Pause button.
8.	After the program has finished, check underneath the DishDrawer for
	water leakage. Ensure machine has run and drained correctly.
9.	Check water supply and drainage connection for leakage.
10.	Repeat for each Drawer.

STEP 8.2 TROUBLESHOOTING

1.	Water underneath DishDrawer; check the hose connections and hose for
	leaks.
2.	Water around water supply and drainage connections - check connections,
	existing plumbing and hoses for leaks.
3.	Excessive water remaining above the filter plate, after the rinse cycle;
	check for kinked drain hoses or blocked waste connection.
4.	No water supply; check water is on and there is water pressure.
5.	If a fault occurs, consult the Problem Solver Section of the Use &
	Care Manual.
6.	If unable to resolve, contact Customer Care Center.

Ensure Power is connected and is switched ON.

Ensure the water supply is connected and ON.

LEAVE ALL LITERATURE WITH THE CUSTOMER.