Fisher & Paykel OR90L installation instructions Cooktop troubleshooting, Problem

Page 29

Cooktop troubleshooting

Problem

Possible solutions

27

My cooktop burners do not light

Check the cooker is switched on.

 

Check the gas supply valve is turned on and the

 

supply to the house is working. You should hear the

 

gas when you turn a burner on.

 

The ignitors may be dirty. Clean them with a

 

toothbrush and methylated spirits.

 

The burner parts may not be located properly. Check

 

the assembly and make sure the burner cap is sitting

 

flat.

 

 

My burner flames are yellow or hard to start

The burner parts may not be located properly. Check the assembly and make sure the burner cap is sitting flat.

If you use bottled gas this may indicate you are getting near the end of the bottle.

Check the burner parts are clean and dry.

The gas pressure may not be at the correct level. Check with your service person or installer.

Your cooker may not be set up for the gas you are using. Check this with your service person or installer.

One of my burners has an uneven

Check the burner parts are clean and dry. Check the

flame

assembly and make sure the burner cap is sitting flat.

The flame goes out at low settings

The gas supply pressure may be low. Check this with

 

your service person or installer.

 

The low setting may have been adjusted incorrectly.

 

Check this with your service person or installer.

 

 

My burners do not turn down much (when running on bottled gas or LPG)

Your cooktop may not have been adjusted correctly. Check this with your service person or installer.

The flame tips are very yellow

Call your service person to service the cooker.

 

 

There are objectionable odours

Call your service person to service the cooker.

The flame appears to lift off the burner

Call your service person to service the cooker.

There is an electricity failure

If there is an electricity failure, you can still use your

 

cooktop. Light the burners by holding a match close

 

to the side of the burner and turning the control

 

knob to the High position. Wait until the flame is

 

burning evenly before adjusting.

Image 29
Contents Installation instructions Page Contents Installation Safety and warningsThis film before using the cooker Switch must always be accessible General Operation Explosion HazardSafety and warnings Important safety precautions Do not use a steam cleaner to clean any part of the cooker Safety and warnings Safety and warnings Within 500 mm of the sides Installation instructionsLevelling the cooker Fitting the adjustable feetBackguard Moving the cookerFitting a stability bracket Anti-Tilt BracketGas connection Gas installation GB & IE onlyVentilation requirements GB & IE only Do not use a naked flame to test for leaks To replace the injectors Replacement of burner injectorsAdjusting the minimum burner setting Adjusting The Minimum Burner SettingLubrication of the gas taps Table for the choice of the injectorsPower Supply Connecting the feeder cableGas cooktop controls Introducing your cookerGas burners Using your gas cooktopLighting the cooktop Before using your cooktopFlame failure safety feature If the flame is irregular If the cooktop does not lightWok stand Choosing a burnerDiameters of pans which may be used on the cooktop Problem Cooktop troubleshootingUsing your oven for the first time Using your main multifunction oven for the first timeClock and timer Function knob Using your main ovenBake Cooking functionsFAN Bake Automatic cooking Correct position of shelf and pan Using your compact multifunction oven for the first timeCooking functions Using your compact ovenDefrost Compact oven fat filter To use the shelf for cooking Using the dish-warming shelfTo use the shelf to hold dishes General advice Care and cleaningCleaning the outside of the cooker Cleaning the gas cooktopReplacing the burners Burner parts and pan supportsGas taps Replacing the triple ring wok burnerRemoving the side racks Cleaning the inside of your ovensCleaning the fat filter Cleaning the enamel cavityStorage compartment Storage compartmentTo refit the door Removing and refitting the oven doorsTo remove the door To remove the glass pane Cleaning the oven door glassCheck the rubber pads are in place To refit the glass paneRemoving either oven lamp Replacing the oven lampBefore you call for service or assistance Warranty and servicePage Page Page Page GB IE