Fisher & Paykel OR90L installation instructions This film before using the cooker

Page 5

Safety and warnings

3

Some appliances have a protective film. Remove

this film before using the cooker.

After unpacking the appliance, check to to ensure it is not damaged and the door closes correctly. If in doubt, do not use it and consult your Authorised Dealer or a professionally qualified technician.

Electrical

This cooker is to be installed and connected to the electricity supply only by an authorised person.

If the installation requires alterations to the domestic electrical system call a qualified electrician. He should also check that the electrical system is suitable for the electricity drawn by the cooker.

The appliance must be connected to the mains, checking that the voltage corresponds to the value given in the rating plate and that the electrical cable sections can withstand the load specified on the plate.

A suitable disconnection switch must be incorporated in the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. The switch must be of an approved type installed in the fixed wiring and provide a 3 mm air gap contact separation in all poles in accordance with the local wiring rules.

Image 5

Contents Installation instructions Page Contents Installation Safety and warningsThis film before using the cooker Switch must always be accessible General Operation Explosion HazardSafety and warnings Important safety precautions Do not use a steam cleaner to clean any part of the cooker Safety and warnings Safety and warnings Within 500 mm of the sides Installation instructionsLevelling the cooker Fitting the adjustable feetBackguard Moving the cookerFitting a stability bracket Anti-Tilt BracketGas connection Gas installation GB & IE onlyVentilation requirements GB & IE only Do not use a naked flame to test for leaks To replace the injectors Replacement of burner injectorsAdjusting the minimum burner setting Adjusting The Minimum Burner SettingLubrication of the gas taps Table for the choice of the injectorsPower Supply Connecting the feeder cableGas cooktop controls Introducing your cookerGas burners Using your gas cooktopLighting the cooktop Before using your cooktopFlame failure safety feature If the flame is irregular If the cooktop does not lightWok stand Choosing a burnerDiameters of pans which may be used on the cooktop Problem Cooktop troubleshootingUsing your oven for the first time Using your main multifunction oven for the first timeClock and timer Function knob Using your main ovenBake Cooking functionsFAN Bake Automatic cooking Correct position of shelf and pan Using your compact multifunction oven for the first timeCooking functions Using your compact ovenDefrost Compact oven fat filter To use the shelf for cooking Using the dish-warming shelfTo use the shelf to hold dishes General advice Care and cleaningCleaning the outside of the cooker Cleaning the gas cooktopReplacing the burners Burner parts and pan supportsGas taps Replacing the triple ring wok burnerRemoving the side racks Cleaning the inside of your ovensCleaning the fat filter Cleaning the enamel cavityStorage compartment Storage compartmentTo refit the door Removing and refitting the oven doorsTo remove the door To remove the glass pane Cleaning the oven door glassCheck the rubber pads are in place To refit the glass paneRemoving either oven lamp Replacing the oven lampBefore you call for service or assistance Warranty and servicePage Page Page Page GB IE