Maintenance, Lights, Halogen Light Replacement

MAINTENANCE

Lights

NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not oper- ate, be sure lights are inserted correctly before calling service.

Halogen Light Replacement

• Using a flat edge from a screwdriver or equivalent tool, pry loose the lens cover as shown in Figure 5.

•Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum) halogen light

made for a G-4 base. Follow package direc- tions and do not touch new light with bare hands.

•Reinstall the light and cover.

Figure 4

Heat Lamp Replacement

•Turn heat lamp counterclockwise to remove.

•Replace lamp with either a PAR-38 175W heat lamp or a PAR-40 250W heat lamp.

The PAR-38 175W heat lamp provides a tighter seal within the enclosure and produces the same amount of effective heat with lower energy con- sumption. These lamps may not be readily available at local retail outlets. The PAR-40 250W heat lamp is more widely available. It can be used instead.

PAR-38 175W heat lamps can be purchased through the following retailers:

•OpTech Inc: 800-848-6624

•bulbs.com: 888-455-2800 or www.bulbs.com

Figure 5

CAUTION

Do not touch the bulbs immediately after use. The bulbs will remain hot for several minutes. Do not place highly flammable material on warming shelves.

PAGE 7