Philips MCM190 Tape Operation / Recording, Tape playback, General information on recording

Page 15

Tape Operation / Recording

Tape playback

1Select TAPE source.

Display: shows throughout tape operation.

2Open the tape key flap marked

OPEN•CLOSE” on the front panel.

3Press STOP•OPENÇ0 to open the tape door.

4Insert a recorded tape and close the tape door. Load the tape with the open side downward and

the full spool to the left.

5Press PLAY 2 to start playback.

The key is automatically released at the end of a tape, except if PAUSE; has been activated.

6To pause, press PAUSE;. Press again to resume.

7By pressing à or á on the system fast winding of tape is possible in both directions.

8To stop the tape, press STOP•OPENÇ0.

Note:

– The sound source cannot be changed while playing or recording a tape.

General information on recording

Recording is permissible insofar as copyright or other rights of third parties are not infringed.

For recording, use only NORMAL (IEC type I) tapes on which the tabs have not yet been broken.This deck is not suited for recording on METAL (IEC IV) type tapes.

The best recording level is set automatically. Altering the VOLUME, INCREDIBLE SURROUND, DBB or INTERACTIVE SOUND controls will not affect the recording in progress.

The recording sound quality might differ depending on the quality of your recording source and the recording tape.

At the very beginning and end of the tape, no recording will take place during the 7 seconds when the leader tape passes the recorder heads.

To protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. If, however, you wish to record over this side again, cover the tabs with a piece of adhesive tape.

Synchro start CD recording

1Select CD source.

2Insert a disc and if desired, programme track numbers.

3Press STOP•OPENÇ0 to open the tape door.

4Insert a suitable tape into the deck and close the tape door.

5Press RECORD to start recording.

Playing of the CD programme starts automatically from the beginning of the CD after 7 seconds. It is not necessary to start the CD player separately.

English

15

Image 15
Contents Manual do usuário Micro Hi-Fi SystemCopyright in the U.K How to connect a plugImportant notes for users in the U.K Mains plugVOL Klass 1 laseraparat 146 104118 132Contents Environmental Information Supplied accessoriesSafety Information General InformationAntenna Connection MW Antenna PowerPreparations Rear connectionsInserting batteries into the remote control FM AntennaSpeakers Connection Front Speakers Controls available on the remote control only Controls on the system and remote controlBasic Functions Adjusting volume and soundSwitching the system on To switch the system to standby modePlaying an MP3 disc CD/MP3 OperationLoading a disc Basic playback controlsErasing the programme Different play modes Shuffle and RepeatProgramming track numbers Reviewing the programmeRadio Reception Tuning to radio stationsTuning to preset radio stations Tune to your desired station see Tuning to radio stationsSynchro start CD recording Tape Operation / RecordingTape playback General information on recordingRecording from the radio MaintenanceActivating and deactivating Clock/TimerSetting the clock Setting the timerSpecifications TroubleshootingNo Disc is displayed Check the speaker connections and location