Philips MCM190 user manual Check the speaker connections and location

Page 19

Radio reception is poor.

Recording or playback cannot be made.

The tape deck door cannot open.

The system does not react when buttons are pressed.

Sound cannot be heard or is of poor quality.

The left and right sound outputs are reversed.

The remote control does not function properly.

The time is not working.

The Clock/Timer setting is erased.

If the signal is too weak, adjust the antenna or connect an external antenna for better reception.

Increase the distance between the Mini HiFi System and your TV or VCR.

Clean deck parts, see “Maintenance”.

Use only NORMAL (IEC I) tape.

Apply a piece of adhesive tape over the missing tab space.

Remove and reconnect the AC power plug and switch on the system again.

Remove and reconnect the AC power plug and switch on the system again.

Adjust the volume.

Disconnect the headphones.

Check that the speakers are connec ted correctly.

Check if the stripped speaker wire is clamped.

Make sure the MP3-CD was recorded within

32-256 kbps bit rate with sampling frequencies at 48 kHz, 44.1 kHz or 32 kHz.

Check the speaker connections and location.

Select the source (CD or TUNER, for example) before pressing the function button (É,í,ë).

Reduce the distance between the remote control and the system.

Insert the batteries with their polarities (+/– signs) aligned as indicated.

Replace the batteries.

Point the remote control directly towards the IR sensor.

Set the clock correctly.

Press and hold TIMER to switch on the timer.

If recording or tape dubbing is in progress, stop recording.

Power has been interrupted or the power cord has been disconnected. Reset the clock/timer.

English

19

Image 19
Contents Manual do usuário Micro Hi-Fi SystemCopyright in the U.K How to connect a plugImportant notes for users in the U.K Mains plugVOL Klass 1 laseraparat 146 104118 132Contents Environmental Information Supplied accessoriesSafety Information General InformationAntenna Connection MW Antenna PowerPreparations Rear connectionsFM Antenna Inserting batteries into the remote controlSpeakers Connection Front Speakers Controls available on the remote control only Controls on the system and remote controlBasic Functions Adjusting volume and soundSwitching the system on To switch the system to standby modePlaying an MP3 disc CD/MP3 OperationLoading a disc Basic playback controlsErasing the programme Different play modes Shuffle and RepeatProgramming track numbers Reviewing the programmeRadio Reception Tuning to radio stationsTuning to preset radio stations Tune to your desired station see Tuning to radio stationsSynchro start CD recording Tape Operation / RecordingTape playback General information on recordingRecording from the radio MaintenanceActivating and deactivating Clock/TimerSetting the clock Setting the timerTroubleshooting SpecificationsNo Disc is displayed Check the speaker connections and location