GE 197D4613P004 installation instructions Tips Troubleshooting

ge.com

Problem	Possible Causes	What To Do
Appliance has odor	Interior needs cleaning.	• See Care and cleaning.
Moisture forms on	Not unusual during periods	•Wipe surface dry.
outside of appliance	of high humidity.
Moisture collects inside	Too frequent or too long
(in humid weather,	door openings.
air carries moisture
	Wine bottles touching	• Reposition bottles.
into appliance when
	the back wall.
door is opened)
Frost forms on interior	This is normal.	• See the Defrosting section.
surfaces of appliance
	Door left open.	• Excessive frost may form if the door is left open.
		See the Defrosting section.
		•Door is not self-closing. Always make sure that
		the door is closed after opening.
		•Check to see if a bottle is holding door open.
Appliance too cold	Temperature control	•See About the control and settings.
	is set too cold.
	The room temperature where	•For proper operation, the room temperature should
	the appliance is located is	be equal to or greater than the set temperature
	too cold.	of the appliance.
Temperature in the	This is normal.	• After you set the temperature, the display will go
display is not the		back to showing the actual temperature.
temperature that
was just set.
Condensation on front	Appliance is located	• Wipe off the condensation with a clean, dry cloth.
of door	in a high humidity environment. • Locate the appliance in a lower humidity
		environment.
Water on floor behind	Door left open.	• Door is not self-closing. Always make sure that
appliance		the door is closed after opening.
		• Check to see if a bottle is holding door open.
	Tilting unit when moving.	• This is normal. The drain pan above the compressor
		may be full following defrost. Check to make sure
		no water spills when moving the unit.

11

Safety Instructions
Instructions	Installation

Operating

Care and Cleaning

Instructions

Tips Troubleshooting

Consumer Support