REFRIGERATOR INSTALLATION
POSITIONING AND LEVELING THE REFRIGERATOR
Now that the refrigerator has been assembled, position and level the refrigerator.
The refrigerator has two front leveling
NOTE: Make sure it meets all the requirements listed on page 9.
1.Plug the refrigerator’s power cord into a
2.Open the refrigerator door and place a level on the lower shelf. Check to make sure it is level from side to side and front to back.
NOTE: Having someone push backward against the top of the refrigerator takes some weight off the leveling legs. This makes it easier to adjust the legs.
3.If it is not level, adjust the front leveling legs until the refrigerator is level. Using a screwdriver, turn the leg counterclockwise to extend the leg and raise the refrigerator at that point. Turn the leg clockwise to retract the leg and lower the refrigerator at that point. It may take several turns of the leveling leg to adjust the tilt of the refrigerator.
4.Open both doors again and check to make sure that they close easily. If not, tilt the refrigerator slightly more to the rear by turning both leveling legs clockwise.
It may take several more turns, and you should turn both leveling legs the same.
5.Readjust if necessary.
WARNING
Both control levers must be securely touching the floor to avoid possible personal injury or property damage because of tipping.
When the left side is higher.
When the left side is lower.
| Control Lever |
Control Lever | Screwdriver |
|
Screwdriver
16