Alto-Shaam 500-S, Holding Cabinet, 300-S, 1200-UP, 750-S, 1000-UP, 1000-S, 1200-S manual Se rv i ce

Page 26

se rv i ce

the rmostat accuracy

The electronic thermostat is a precise instrument and is designed to offer trouble free service. If you suspect the temperature inside the holding compartment does not match the temperature indicated on the digital display, follow the instructions listed below.

1.Check to make certain the unit voltage matches the power source. A power source less than that required to operate the unit will result in inaccurate temperatures.

Danger

DISConneCt UnIt FroM Power SoUrCe beFore CleanIng or SerVICIng.

2.Verify the temperature inside the holding compartment with a quality thermal indicator.

a.With the exception of the wire shelves, completely empty the holding compartment.

b.Make certain the holding cabinet sensor, located inside the holding compartment at the left side of the unit, is completely clean.

c.Suspend the thermal indicator in the center of the holding compartment.

d.Allow the temperature set on the electronic thermostat to stabilize for a minimum of one hour before comparing the digital display with the reading on the thermal indicator.

DO NOT OPEN THE CABINET DOOR(S) DURING THE TEMPERATURE STABILIZATION PERIOD.

If the reading on the thermal indicator does not match the digital display, there may be a problem with the air sensor. See troubleshooting guide in this manual; or call the factory service department for advice.

troubleshooting

CaUtIon

THIs sECTION Is PROVIDED FOR THE AssIsTANCE OF QUALIFIED sERVICE TECHNICIANs ONLY AND Is NOT INTENDED FOR UsE BY UNTRAINED OR UNAUTHORIZED sERVICE PERsONNEL.

This section is provided for the assistance of qualified technicians only and is not intended for use by untrained or unauthorized service personnel. If your Alto-Shaam®unit is not operating properly, check the following before calling your Authorized Alto-Shaam Service Agent:

Check main power circuit breaker to the unit and verify that the circuit breaker on the back of the unit is turned on, if applicable.

Do not attempt to repair or service the unit beyond this point. Contact Alto-Shaam for the nearest authorized service agent. Repairs made by any other service agents without prior authorization by Alto-Shaam®will void the warranty on the unit.

Danger

DISConneCt UnIt FroM Power SoUrCe beFore CleanIng or SerVICIng.

CaUtIon

THIs sECTION Is PROVIDED FOR THE AssIsTANCE OF QUALIFIED sERVICE TECHNICIANs ONLY AND Is NOT INTENDED FOR UsE BY UNTRAINED OR UNAUTHORIZED sERVICE PERsONNEL.

holding cabinets installation/operation/service manual - pg. 24

Image 26
Contents Installation Sanitation L I V e r y P a C K I n gSaFety ProCeDUreS anD PreCaUtIonS N g e rMinimum clearance Requirements Metal PARTs of THIs EquipmentNFPA96 2004 Edition, Par .1.1.2. U.L 300-S 500-S750-S 1000-S1000-UP 1200-SSide Racks and Shelves 1200-UPPan slides 2 per set 1-3/4 44mm centers Side Racks and Shelves optional Two 2 slides needed per panOptions and Accessories DescriptionStacking Configurations Model Can be stacked with StaCKIng InStrUCtIonSMaximum height of casters is 6 152mm RISK oF eleCtrIC SHoCKAppliance must be secured To building structure Drip tray installation instructions 500, 750, 1000 Hard wired models ECT RI CA L300-S SE R Information To toggle between Set and Actual Preheat AT 200F 93C for 30 minutes before loading foodPress the Up or Down Arrow Keys to 200F 93C Load the cabinet with hot food onlyDeluxe Control With multiple timers Preheat at 200F 93C for 30 minutes SureTemp Heat RecoveryReset the control to 160F 71C Load with hot food onlyTimer Programming Information Water vapor, or steam. Maintaining maximum Decrease in temperature, excessive condensation willHalo Heat maintains the maximum amount of product ProteCtIng StaInleSS Steel SUrFaCeS CleanIng agentSCleanIng MaterIalS Cause oxidation and pitting that result in rustWarranty BECOMEs Void if Appliance Is Flooded SeVere DaMage or eleCtrICal HaZarD CoUlD reSUltSa nit a tio n Se rv i ce To test probe and air sensor Code Description Possible CauseSingle Compartment 300-S Shown Single Compartment 500-S, 750-S, 1000-S, 1200-S Side PanelUP Shown Model 1000-UP 1200-UP Rv i ce Deluxe Control Electronic Components Cable Heating Service KitS Cable heating kit #4874 #4881 #4978Page Page Page     Page Page Page        Transportation Damage and Claims Voltage Purchased From
Related manuals
Manual 43 pages 62.68 Kb Manual 2 pages 2.17 Kb Manual 48 pages 14.35 Kb

1200-S, 1000-S, 1000-UP, 750-S, 1200-UP specifications

Alto-Shaam has long been a frontrunner in the realm of commercial cooking equipment, and their latest offerings, the Alto-Shaam 1200-UP and 1200-S, exemplify their commitment to innovation, quality, and efficiency. Designed for operators across diverse foodservice settings, these units combine precision cooking with versatility to meet the demands of modern kitchens.

The Alto-Shaam 1200-UP features a unique, patented Halo Heat technology. This innovation utilizes a gentle, consistent heat that surrounds food, ensuring even cooking without excessive drying. This technology excels in maintaining food quality and allows for holding foods at optimal serving temperatures without compromising on taste or texture. This makes it ideal for busy restaurants, catering events, and even institutional settings.

On the other hand, the Alto-Shaam 1200-S offers similar cooking capabilities but is tailored for different operational needs. It features a robust design to handle high-volume demands while maintaining reliability and efficiency. Both models are designed with user-friendly controls, enabling chefs to set precise temperatures and times for various cooking applications.

The Alto-Shaam 1200-UP and 1200-S come equipped with digital smart controls that facilitate intuitive operation. Programmable settings allow for easy customization, enabling operators to save time and maximize productivity during peak service periods. The precise temperature control provided by these systems minimizes food waste and ensures consistency, which is crucial in a high-paced culinary environment.

Another significant characteristic of these models is their energy efficiency. Both the 1200-UP and 1200-S utilize advanced insulation technology to retain heat, reducing energy consumption and operational costs. This sustainable design not only benefits the bottom line but also reflects a growing trend towards environmentally responsible cooking practices in the foodservice industry.

Both units offer ample cooking capacity, making them perfect for various food items, whether it be meats, vegetables, or baked goods. Their durable construction ensures longevity, and their sleek design fits seamlessly into any kitchen layout. Additionally, they are equipped with easy-to-clean surfaces, simplifying maintenance and promoting a hygienic work environment.

In summary, the Alto-Shaam 1200-UP and 1200-S stand out with their cutting-edge Halo Heat technology, user-friendly controls, energy efficiency, and versatile cooking options. With these advancements, Alto-Shaam continues to empower foodservice operators to elevate their culinary offerings while optimizing their day-to-day operations.