Amana AOES2430 owner manual Adjusting Oven Height, Cabinet Installation, Checking Operation

Page 7

Adjusting Oven Height

Oven height can be adjusted when needed to fit into an existing cabinet cutout opening. To adjust oven height:

1.Lay the oven on its back.

2.Remove the 6 screws fastening the side of each extension panel to the bottom sides of the oven.

3.Move each panel down to the position that increases the oven height to fit the existing cutout opening. Each position changes oven height approximately 1/2 inch up to 2 inches.

4.Line up the appropriate holes in the side extension panels and sides of the oven. Replace the 6 screws.

5.Proceed with oven installation. Return oven to upright position.

Oven door

Oven bottom

Extension panel

 

 

 

Figure 5 – Extension Panel

 

Cabinet Installation

!CAUTION

Do not lift the oven by the door handle. Preferably, remove the oven door to facilitate handling and prevent damage to the appliance.

Slide the oven all the way into the cabinet opening. Check for level installation with a level on the oven rack. In wood cabinets, drill 1/8-inch pilot holes for No. 10 wood screws through the mounting holes in the front frame. Then mount the oven to the cabinet with the screws furnished.

Locate lower grill assembly and trim adaptors that were removed during unpacking. Carefully break apart the trim adaptors and insert them in each side of the lower grill assembly. Insert the protruding end of the trim assembly into the oven side trim, sliding the assembly up from the bottom. Secure the grill assembly to the cabinet with the two Fillister screws provided.

Fit trim adapter (one each side)

2" Fillister screw

Slide and fit lower grill assembly into oven side trim

Figure 6

Checking Operation

Upon completion of the electrical hookup, the operation of the electronic oven control should be verified. The Bake, Broil, and Clean modes should be checked by operating the electronic control according to the instructions contained in this manual .

7

Image 7
Contents Customer Please Read Manual Before Operating Oven InstallerContents Oven Important Safety InformationRecognize this symbol as a safety precaution All AppliancesCase of Fire Important Safety Information InstallationSelf-Cleaning Oven Location and DimensionsConnecting Wiring Electrical Shock Hazard Side by Side InstallationElectrical Requirements Grounding Instructions Wire Electrical SystemCabinet Installation Adjusting Oven HeightChecking Operation Pads Description Control Pad FeaturesTo enter Special Modes Special ModesSet Clock 12 hour clock Set Minute TimerBefore Setting Oven Controls ProgrammingBake PreheatTimed Bake Rack Position Foods Delayed BakeVariable Setting Doneness BroilAdhere to the following cleaning precautions Prepare Oven for Self-CleaningTo Stop or Interrupt a Self-Cleaning Cycle Self-CleanWhen the Self-Clean Cycle is Completed Delayed Self-Clean Removing Oven Door Reinstalling Oven Door Hinge TypeHinge Type Cleaning Wall Oven Parts Adjusting Oven TemperatureChanging Oven Light Surfaces How to Clean Before You Call for Service During broiling Self-cleaning cycle doesCleaning cycle is Oven smokes excessivelyFirst Year WarrantyPage Page Quick Reference Instructions