Amana AOES2430 owner manual Before You Call for Service

Page 19

Before You Call for Service

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

This oven is equipped with an electronic oven controller. Among its many features is a full time oven circuit diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits, to insure they are all operating correctly. If at any time one of these systems fail, the controller will immediately shut down operation, and will beep and flash an error code of -F1- or -F3- in the display window.

OCCURRENCE

POSSIBLE CAUSE/SOLUTION

 

 

Oven Control Beeps and

Electronic control has detected a fault condition. Push OVEN CANCEL pad to clear

Displays -F1- or -F3-.

the display and stop the display from beeping. Reprogram the oven. If a fault recurs,

 

record the fault number, push OVEN CANCEL pad and contact an authorized

 

servicer.

 

 

Oven is not level.

Poor installation. Place a level on an oven rack in center of oven. Contact installing

 

agent if rack is not level; unit may be shimmed underneath. Refer to Installation

 

Instructions.

 

 

Entire appliance does not

When the oven is first plugged in, or when the power supply to the oven has been

operate.

interrupted, the display will flash. The oven cannot be programmed until the clock is

 

set to the time of day.

 

Make sure electrical cable is securely connected and grounded into electrical circuit.

 

Service wiring not complete. Contact your dealer, installing agent or authorized

 

servicer.

 

Power outage. Check house lights to be sure. Contact your local electric company.

 

Short in electrical cable. Contact your dealer, installing agent or authorized servicer.

 

Electronic controls are not set properly. See instructions under “Programming”

 

section.

 

House fuse has blown or circuit breaker has tripped immediately following

 

installation. House fuse may not be fully engaged. Check fuse or engage circuit

 

breaker securely.

 

House fuse has blown or circuit breaker has tripped after the oven has been installed

 

and previously operating. Call an authorized servicer.

 

 

Oven light does not work.

Burned out or loose bulb. Follow instructions under “Changing Oven Light” to replace

 

or tighten the bulb.

 

 

19

Image 19
Contents Customer Please Read Manual Before Operating Oven InstallerContents Oven Important Safety InformationRecognize this symbol as a safety precaution All AppliancesCase of Fire Important Safety Information InstallationSelf-Cleaning Oven Location and DimensionsConnecting Wiring Electrical Shock Hazard Side by Side InstallationElectrical Requirements Grounding Instructions Wire Electrical SystemCabinet Installation Adjusting Oven HeightChecking Operation Pads Description Control Pad FeaturesTo enter Special Modes Special ModesSet Clock 12 hour clock Set Minute TimerBefore Setting Oven Controls ProgrammingBake PreheatTimed Bake Rack Position Foods Delayed BakeVariable Setting Doneness BroilAdhere to the following cleaning precautions Prepare Oven for Self-CleaningTo Stop or Interrupt a Self-Cleaning Cycle Self-CleanWhen the Self-Clean Cycle is Completed Delayed Self-Clean Removing Oven Door Reinstalling Oven Door Hinge TypeHinge Type Cleaning Wall Oven Parts Adjusting Oven TemperatureChanging Oven Light Surfaces How to Clean Before You Call for Service During broiling Self-cleaning cycle doesCleaning cycle is Oven smokes excessivelyFirst Year WarrantyPage Page Quick Reference Instructions