Amana W10245579A, W10212195A Install Drain Hose, Connect Drain Hose to Air Gap-Waste Disposer

5.Turn on the water shutoff valve. Run water into a shallow pan to flush the water line (copper tubing or flexible braided water supply line) of particles that may clog the inlet valve.

6.Turn off the water shutoff valve.

Install Drain Hose

IMPORTANT: Always use a new drain hose even when installing a new replacement dishwasher.

■Drill a 1¹⁄₂" (3.8 cm) diameter hole in the cabinet wall on the side of the opening closest to the sink.

Connect Drain Hose to Air Gap—Waste Disposer

1.Remove the waste disposer knockout plug. Cut the end of the drain hose, if needed.

NOTE: Do not cut the ribbed section.

2.Attach the drain hose to the air gap with the large drain hose clamp (provided).

NOTE: If the drain hose was cut, use 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided).

3.Use a rubber hose connector (not provided) with screw-type clamps (not provided) to connect the air gap to the waste disposer inlet above the drain trap and at least 20" (50.8 cm) above the floor.

A

B

C

D

		E
H
	G	F
A. Drain hose—cut here, if needed	E. Drain hose
B. Screw-type clamps	F. Rubber hose connector
C. Air gap	(not provided)
D. Large drain hose clamp	G. Disposer inlet
(provided)	H. Drain trap

4.Insert the drain hose through the hole cut in the cabinet and to the front and center of the opening where the drain connection will be made.

A

A. Drain hose

Connect Drain Hose to Air Gap—No Waste Disposer

1.Cut the end of the drain hose, if needed. NOTE: Do not cut the ribbed section.

2.Attach the drain hose to the air gap with the large drain hose clamp (provided).

NOTE: If the drain hose was cut, use 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided).

7