Amana W10212195A Make Electrical Connections-Power Supply Cord Method, Prepare Terminal Box

Prepare Terminal Box

1.Using a ¹⁄₄" hex-head socket, nut driver or Phillips screwdriver, remove the terminal box cover. Lay the cover aside.

2.Install a UL-listed/CSA-approved conduit connector (may be provided in power supply cord kit [Part Number 4317824]). Check that screwheads are facing to the left when tightening the conduit nut.

NOTE: If your dishwasher will be connected by the direct wire connection, please see “Adjust Leveler Legs.”

Make Electrical Connections—Power

Supply Cord Method

WARNING

Electrical Shock Hazard

Electrically ground dishwasher.

Connect ground wire to green ground connector in terminal box.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

The power supply cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances. Install the power supply cord according to the installation instructions included with the power supply cord kit.

1.Route the power supply cord so that it does not touch the dishwasher motor or the lower part of the dishwasher tub.

2.Pull the power supply cord through the conduit connector in the terminal box.

3.Remove the green grounding screw and place the screw through the ring terminal of the green ground wire. Reattach and tighten the green grounding screw.

A

A

B

C

A. Green ground wire

B.Washer

C.Green grounding screw

4.Using UL-listed/CSA approved twist-on connectors sized to connect the power supply cord to 16-gauge dishwasher wire, connect the white wire from the power supply cord to the white wire on the terminal box.

10