Amana ASD2275BRB, ASD2575BRW Make sure it is a cold water pipe, Connect to Refrigerator

Page 9

IMPORTANT:

Make sure it is a cold water pipe.

Horizontal pipe will work, but drill on the top side of the pipe, not the bottom. This will help keep water away from the drill and normal sediment from collecting in the valve.

4.Determine the length of copper tubing you need. Measure from the connection on the lower rear corner of refrigerator to the water pipe. Add 7 ft (2.1 m) to allow for cleaning. Use ¹⁄₄" (6.35 mm) O.D. (outside diameter) copper tubing. Be sure both ends of copper tubing are cut square.

5.Using a cordless drill, drill a ¹⁄₄" (6.35 mm) hole in the cold water pipe you have selected.

 

A

G

B

 

 

C

F E

D

A. Cold water pipe

E. Compression sleeve

B. Pipe clamp

F. Shutoff valve

C. Copper tubing

G. Packing nut

D. Compression nut

 

6.Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so the washer makes a watertight seal. Do not overtighten, or you may crush the copper tubing.

7.Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the end of the tubing into the outlet end squarely as far as it will go. Screw the compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing in a container or sink, and turn ON the main water supply. Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe. Coil the copper tubing.

Connect to Refrigerator

Style 1

1.Unplug refrigerator or disconnect power.

2.Remove and discard the short, black plastic part from the end of the water line inlet.

3.Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

Style 2

1.Unplug refrigerator or disconnect power.

2.Remove and discard the plastic part that is attached to the inlet of the water valve.

3.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten.

4.Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

 

A

 

B

 

C

 

D

 

E

A. Tube clamp

D. Compression nut

B. Tube clamp screw

E. Valve inlet

C. Copper tubing

 

7.On some models, the ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer.

Style 3

1.Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.If the gray water tube supplied with the refrigerator is not long enough, a ¹⁄₄" x ¹⁄₄" (6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A

B

C

D

 

A. Household water line

C. Ferrule (purchased)

 

B. Nut (purchased)

 

D. Refrigerator water tubing

4.Install the water supply tube clamp around the water supply line to reduce strain on the coupling.

A

B

C

D

E F G

A. Refrigerator water tubing

 

E. Ferrule (purchased)

B. Nut (provided)

 

 

F. Nut (purchased)

C. Bulb

 

 

 

G. Household water line

D. Coupling (purchased)

 

 

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

9

Image 9
Contents Refrigerator User Instructions Refrigerator Safety Installation Instructions Unpack the RefrigeratorBefore You Throw Away Your Old Refrigerator or Freezer Tools Needed Door Removal, Leveling and AlignmentUnplug refrigerator or disconnect power Replace the Doors and HingesLeveling and Door Closing To Install the Handles Handle Installation and RemovalTo Remove the Handles Door AlignmentElectrical Requirements Location RequirementsWater Supply Requirements Recommended Grounding MethodReverse Osmosis Water Supply Connect Water SupplyStyle 1 Recommended StyleConnect to Refrigerator Make sure it is a cold water pipeCONDITION/REASON Adjustment Using the ControlsRefrigerator USE Crisper Humidity ControlTo Dispense Ice To Dispense WaterWater Dispenser Press the Water button to select waterWater Filtration System Ice Maker and Storage Bin To Clean Your Refrigerator CleaningNon-Indicator Water Filter on some models Refrigerator CareVacation and Moving Care LightsIf You Choose to Turn Refrigerator Off Before You Leave MovingProblem Solver Possible Causes and/or Recommended SolutionsGeneral Operation Doors and Leveling ICE and Water Possible Causes and/or Recommended SolutionsIce or water has an ProperlyOff-taste, odor Or gray colorWater Filter Certifications AccessoriesAffresh Stainless Steel Wipes Water FilterWater Filtration System Performance Data SheetLimited Warranty Amana Major Appliance WarrantyItems Excluded from Warranty This limited warranty does not coverSeguridad DEL Refrigerador Instrucciones Para EL Usuario DEL RefrigeradorInstrucciones DE Instalación Desempaque el refrigeradorAntes de tirar su viejo refrigerador o congelador Herramientas Necesarias Remoción, nivelación y alineamiento de las puertasQuite las puertas Vuelva a colocar las puertas y las bisagrasNivelación y cierre de las puertas Para instalar las manijas Cómo instalar y remover las manijasPara quitar las manijas Alineamiento de las puertasRequisitos eléctricos Requisitos de ubicaciónRequisitos del suministro de agua Método de conexión a tierra recomendadoSuministro de agua de ósmosis inversa Conexión del suministro de aguaEstilo 1 Recomendado Presión del aguaConexión al refrigerador EstiloUso de los controles USO DE SU RefrigeradorCómo terminar la instalación Ajuste de los controlesDespachadores de agua y hielo Control de humedad del Cajón para verdurasPara despachar agua CONDICIÓN/MOTIVO AjustePara despachar hielo Fábrica de hielo y depósitoLa luz del despachador El bloqueo del despachadorSistema de filtración de agua Limpieza Cuidado DE SU RefrigeradorLuces Cuidado durante las vacaciones MudanzasFuncionamiento Solución DE ProblemasCausas posibles y/o soluciones recomendadas EN GeneralParece ruidoso El refrigeradorLos ruidos que se indican a continuación son normales La temperatura estáLas luces del Puertas Y NivelaciónDespachador En algunos modelosHielo Y Agua Causas posibles y/o soluciones recomendadasDeshágase de los tres primeros lotes de hielo producidos El despachador de Hielo no funcionaDebidamente Accesorios Sistema de filtración de agua Hoja DE Datos DEL RendimientoGarantía Limitada Garantía DE LOS Electrodomésticos Principales DE AmanaExclusiones DE LA Garantía Esta garantía limitada no cubreAmana Brand Home Appliances Sécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurInstructions Dinstallation Déballage du réfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Outillage Nécessaire Retrait, réglage de laplomb et alignement des portesRéinstaller les portes et les charnières Enlever les portesNivellement et fermeture des portes Installation et démontage des poignées Installation des poignéesAlignement des portes Méthode recommandée de mise à la terre Exigences demplacementSpécifications électriques Retrait des poignéesSpécifications de l’alimentation en eau Style 1 RecommandéRaccordement de la canalisation deau Alimentation en eau par osmose inverseRaccordement au réfrigérateur Sassurer quil sagit d’une canalisation deau froideUtilisation des commandes Achever l’installationUtilisation DU Réfrigérateur Distributeurs deau et de glaçons Réglage de lhumidité dans Le bac à légumesDistribution d’eau CONDITION/RAISON AjustementDistribution de glaçons Le distributeur de glaçonsLa lampe du distributeur Système de filtration de leau Machine à glaçons et bac DentreposageNettoyage Entretien DU RéfrigérateurNettoyage de votre réfrigérateur Changer le filtre à eauEntretien avant les vacances ou Lors d’un déménagement LampesVider le bac à glaçons DéménagementRésolution DE Problèmes Causes possibles et/ou solutions recommandéesUtilisation Générale Semble bruyant Le réfrigérateurLes bruits suivants sont normaux La températureLes lampes du distributeur Portes ET NivellementSur certains modèles Autre réglage. Voir Distributeurs deau et de glaçonsGlaçons ET EAU Causes possibles et/ou solutions recommandéesLe distributeur de Glaçons ne fonctionnePas correctement Accessoires Système de filtration d’eau Feuille DE Données SUR LA PerformanceGarantie Limitée Garantie DES Gros Appareils Ménagers AmanaÉléments Exclus DE LA Garantie La présente garantie limitée ne couvre pasW10452515B

ASD2275BRW, ASD2575BRB, ASD2275BRB, ASD2575BRS, ASD2275BRS specifications

The Amana refrigerator models ASD2575BRW, ASD2275BRS, ASD2575BRS, ASD2275BRB, and ASD2575BRB stand out in the competitive kitchen appliance field, combining utility and sleek aesthetics. These side-by-side refrigerators are designed to cater to modern needs, offering a blend of style, advanced technology, and thoughtful features.

One of the main attractions of these Amana models is their spacious interior layout, making them ideal for families and individuals with busy lifestyles. They offer generous storage space with adjustable shelves that allow users to customize their storage configurations. The shelves are constructed from durable materials, easy to clean and maintain while ensuring they can accommodate large items like tall bottles or bulky containers.

These refrigerators also feature a dual evaporator system for optimal food preservation. This technology allows separate cooling systems for both the refrigerator and freezer compartments, thus reducing the risk of odor transfer and maintaining ideal humidity levels. The Fresh Food section is designed to keep fruits and vegetables crisp, while the freezer maintains low temperatures for long-lasting food preservation.

Energy efficiency is another hallmark of these Amana models. They are equipped with energy-saving features, such as LED lighting and a high-efficiency compressor, which help reduce overall energy consumption without sacrificing performance. These eco-friendly elements not only save money on utility bills but also contribute to a more sustainable lifestyle.

Convenience features are abundant as well, with adjustable door bins that provide flexible storage options and an external water and ice dispenser that offers easy access to chilled water and ice cubes. This saves time and adds a layer of practicality to daily routines.

Additionally, these models offer a sleek finish available in various colors, enhancing any kitchen decor. The fingerprint-resistant stainless steel options ensure that the surface remains clean and attractive over time.

In conclusion, the Amana ASD2575BRW, ASD2275BRS, ASD2575BRS, ASD2275BRB, and ASD2575BRB refrigerators are designed for those who prioritize functionality without compromising style. Their advanced features, coupled with an energy-efficient design, make them an excellent choice for modern households looking to streamline their kitchen experience while keeping food fresh and organized.