Manual ND ISLA UL ing.qxd 6/05/2003 11:50 PÆgina 4
Instructions for use |
| Cleaning and maintenance |
|
|
|
You may control the kitchen hood's workings by operating the controls as shown in the diagram.
ENG
3 2 1
1
2
3
To improve draught we recommend to turn the extractor fan on a few minutes before cooking so that the flow of air is continuous and stable when fumes are extracted.
Similarly, keep the extractor fan on for a few minutes after cooking to completely extract fumes and odours.
Programming timer
1.- By pressing for more than 2 seconds any speed, the kitchen hood will stay switched on for 10 minutes at the selected speed. To program a duration other than 10 minutes:
a).- With the kitchen hood switched off, press “timer”.
b).- Select the required programming time by pressing the chosen button (see drawing). c).- Press “timer” again to record the new program.
d).- Press the chosen speed for more than 2 seconds, the pilot light will start flashing.
When cleaning and doing maintenance, make sure the safety instructions set out on page 2 are complied with.
Cleaning the body of the kitchen hood
•If your kitchen hood is made from stainless steel, use this material's specially designed cleaners following the instructions mentioned in the product supplier´s instructions.
•Never use metallic scourers, nor abrasive or corrosive products.
•Dry the kitchen hood using a cloth that does not produce fluff.
Cleaning the metal filters
To remove the filters from their fittings, press lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using products specially designed for fats. They can also be washed in a dishwasher. In this case, it is advisable to stack them vertically to avoid food residue sticking to them.
Cleaning in a dishwasher with aggressive detergents or polish may damage the metallic surface (blackening it), although this will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit them onto the kitchen hood.
Changing lights
Proceed as follows:
•Unscrew the decorative element of the halogen lamp.
•Change the broken/burnt out lamp. Maximum lamp power is 20 W
•Screw back on the decorative element of the halogen lamp.
4