LG Electronics LCE30845, HN7413AG installation instructions Ro U B L E S H O Ot I N G, Display

T RO U B L E S H O OT I N G

BEFORE CALLING FOR SERVICE

Problem			Possible Causes	Solutions
		appears in the	• Control pad was touched too long.	• This message will appear if any pad except the Timer
timer		display					or			pads is touched for more than 10 seconds.
						It will also appear if liquids or objects are spilled or left
					on the controls area. To clear the error code, remove any
					liquid or objects from the controls area and press the
					POWER pad to reset the cooktop.
		appears in the	• Supplied voltage to cooktop is	•	If the voltage of the power supplied to the cooktop is too
timer	display		too low.		low, it cannot operate properly and will show this error
					code. This may be caused by reduced voltage being
					supplied to the house circuit. If connections are
					correct and the supplied voltage returns to normal,
					the code will disappear.
		appears in the	• Electronics fault error message.	•	Turn the cooktop OFF; then shut off power at the fuse or
display and a number					circuit breaker for about 30 seconds. Turn power back
appears in the timer					on to the cooktop and turn the cooktop on using the
display					POWER pad. If the error message is still displayed, call
					for service.
		flashes in the	• Power outage or initial startup.	•	When the cooktop is first turned on or after a power
					outage,				will blink in the display for 90 minutes or
display
					until the			POWER pad is touched for 2 seconds.

28