Roper FGP335B warranty Removing the oven bottom, Burn Hazard

Page 19

2.Hold the door at the sides near the top. Insert hinge arms into slots at the bottom of the door. Insert arms evenly, as far as they will go.

3.If the door is not in line with the oven frame, remove it and repeat the above steps.

4.Replace the screws on the oven door.

Removing the oven bottom

The panel in the oven bottom can be removed for cleaning.

Burn Hazard

Make sure all parts are cool before removing.

Failure to do so could result in burns.

To remove:

1.Remove oven racks.

2.Remove the two hold-down screws at the rear of the oven. If screws are too tight to remove by hand, use a screwdriver.

3.Place fingers in slots in bottom panel and lift rear of panel up and back until lip at the front of panel is clear of front frame of oven cavity.

4.Lift bottom up and out.

To replace:

1.Place oven bottom panel in oven with the back raised about 6 inches or until you can insert the hold-down lip at front of panel under the front frame of oven cavity.

2.Push back of oven bottom panel down fully into place on metal flanges on rear wall and insert the hold-down screws.

19

Image 19

Contents UseAndCare Thank you for buying a Roper@ appliance Your safety is important to usRead and Save These Instructions Important safety InstructionsWhen using the cooktop Read and Save These Instructions Par& And Features Your Range UsingBurners Cookware tips Case of a prolonged power failureFood Positioning racksPans Home canning informationTwo pans For best air circulationExtra oven rack position roasting rack For proper roasting, follow these guidelinesUsing the Minute Timer Setting the clockBaking/roasting Broiling Adjusting the oven temperatureControl Energy saving tips Burn Hazard Oven ventAnti-tip brackets To verify the anti-tip brackets are engagedSurface burner grates Caring For Your RangeBurn, Electrical Shock, Fire Explosion Hazard Surface burners Lift-up cooktopReplace surface burner grates To replace Removing the oven door+c. =.c.0scre To removeRemoving the oven bottom For cookedon food Cleaning ChartHOW to Clean Control knobs Sponge and warmPart What to USE To replace the oven light Oven lightElectrical Shock and Burn Hazard Solution If You Need Assistance Or ServiceProblem Possible Cause Burner fails to The power cord is notControl knobs Mill not turn Ellow, or are noisy when turned offDisplay is flashing 12OO If you need FSP@ replace- ment parts If you need serviceIf you are not satisfied with how the problem was solved If you need assistanceWE will not PAY for Gas Range WarrantyLength of Warranty WE will PAY for Full ONE-YEAR Warranm