Roper FGP335B warranty Ellow, or are noisy when turned off, Control knobs Mill not turn

Page 24

PROBLEM POSSIBLE CAUSE

Burner flames Air/gas mixture is incorrect. lift off ports, are

/ellow, or are noisy when turned off

Burner makes Burner is wet from washing.

rhgi:i noi=

SOLUTION

Contact an authorized Roper service technician to check air/gas mixture.

Let dry.

Control knob(s)

Mill not turn

Cooking results are not what IOU expected

The display is flashing “12:OO”

You are not pushing in before turning.

The range is not level.

The oven temperature seems too low or too high.

The oven was not preheated as the recipe calls for.

The recipe has never been tested or is not from a reliable source.

The pans are not the type or size recommended in the recipe.

There is not proper air circu- lation around pan when baking.

Flame size does not fit the cooking utensil being used.

When broiling, you have not completely closed the broiler drawer.

There has been a power outage.

Push control knob(s) in before turning to a setting.

Level range. (See Installation

Instructions.)

Adjust the oven temperature control. (See “Adjusting the oven temperature control” on page 13.)

Preheat oven if called for in recipe.

Use only tested recipes from a reliable source.

Refer to a reliable cookbmk for recom- mended pan type and size.

Allow 1% to 2 inches (4-5 cm) on all sides of the pans for air circulation. There must be a minimum space of 1 inch (2.5 cm).

Adjust flame size to fit cooking utensil.

Completely close broiler drawer.

Reset the clock. (See page 11.)

24

Image 24
Contents UseAndCare Your safety is important to us Thank you for buying a Roper@ applianceImportant safety Instructions Read and Save These InstructionsWhen using the cooktop Read and Save These Instructions Par& And Features Using Your RangeBurners Case of a prolonged power failure Cookware tipsPositioning racks PansHome canning information FoodFor best air circulation Extra oven rack position roasting rackFor proper roasting, follow these guidelines Two pansSetting the clock Using the Minute TimerBaking/roasting Adjusting the oven temperature BroilingControl Energy saving tips Oven vent Anti-tip bracketsTo verify the anti-tip brackets are engaged Burn HazardCaring For Your Range Surface burner gratesBurn, Electrical Shock, Fire Explosion Hazard Lift-up cooktop Surface burnersReplace surface burner grates Removing the oven door +c. =.c.0screTo remove To replaceRemoving the oven bottom Cleaning Chart HOW to CleanControl knobs Sponge and warm For cookedon foodPart What to USE Oven light To replace the oven lightElectrical Shock and Burn Hazard If You Need Assistance Or Service Problem Possible CauseBurner fails to The power cord is not SolutionEllow, or are noisy when turned off Control knobs Mill not turnDisplay is flashing 12OO If you need service If you are not satisfied with how the problem was solvedIf you need assistance If you need FSP@ replace- ment partsGas Range Warranty Length of Warranty WE will PAY for Full ONE-YEARWarranm WE will not PAY for