Liebherr 20707 Changing the door hinges, To detach the soft stop mechanism, Reversing the door

Fig. 1

Changing the door hinges

u Examine the unit and packaging for shipping damage. Contact the carrier immediately if you suspect there is any damage.

u Note the type (model, number), index, appliance/serial number, date of purchase and where purchased on the spaces provided in see Appliance Information.

u Remove anything attached to the rear or side walls of appliance that would prevent proper installation or impede proper ventilation.

If the appliance is set up in humid areas, condensation may build on the outside of the appliance.

u Always ensure proper ventilation.

3 Changing the door hinges

Make sure you have the following tools on hand: q Hex wrench 13

q Cordless screwdriver Torx 15, 20, 25, 30

Push the appliance 2/3 of the way into the recess. Disconnect the power plug.

Open the doors.

3.1To detach the soft stop mechanism*

HC1011, HC1060

CAUTION

Risk of injury if soft stop contracts! u Detach with care.

u Unscrew retainer Fig. 1 (1).

u Unscrew ball stud Fig. 1 (3) together with the soft stop mechanism Fig. 1 (2) from the door and set to one side.

3.2 Reversing the door

Fig. 2 u Lift off covers Fig. 2 (5,6,7,8) using a slot screwdriver. u Just loosen top and bottom screws Fig. 2 (9) on the body

of the appliance.

u Push doors outwards and unhook.

u Swap screws Fig. 2 (9) to the opposite side and screw them in a little.

CAUTION

Risk of injury if hinges fold! u Leave hinges open.

u Undo screws Fig. 2 (10) and change over the hinges diagonally.

The screws Fig. 2 (10) are self-tapping: use a cordless screwdriver.

u Tighten the hinges.

u Close off the now unused fastening holes with the plugs Fig. 2 (11) supplied.

u Hang doors on the pre-fitted screws Fig. 2 (9) and tighten screws.

3.3Re-attaching the soft stop mechanism*

HC1011, HC1060

u Screw on retainer Fig. 3 (1).

Fig. 3

3