Safety instructions and warnings

The ice maker is ﬁtted in the freezer compartment of the combined refrigerator-freezer. It must be connected to the mains water supply to work. The descriptions below only relate to the ice maker and the water connection to a solenoid valve. All the instructions and details for the appliance as a whole are set out in the enclosed operating instructions for the combined refrigerator-freezer.

The ﬂoor on which the appliance stands should be horizontal and level. To compensate for any unevenness, adjust the height of the feet with the open-ended wrench supplied. The combined refrigerator-freezer must stand level.

•Do not make the water connection whilst the combined refrig- erator-freezer is connected to the electricity supply.

•The connection to the mains water supply may only be made by a trained plumber.

•The water quality must comply with the drinking water di- rectives of the country in which the appliance is used.

•The ice maker is designed exclusively to make ice cubes in quantities required by a household and may only be operated with water suitable for this purpose.

•All repairs and work on the ice maker may only be carried out by customer service personnel or other trained personnel.

•The ﬁrst three batches of ice must not be consumed or used. This applies both to using the appliance for the ﬁrst time and also to using it after it has not been used for a lengthy period of time. This ensures that the water supply is purged.

•The manufacturer cannot accept liability for damage caused by a faulty connection to the mains water supply.

Instructions for trained personnel

Position of the water connection

Position of the water connection if a 1.5 m hose is used. This hose is supplied with the appliance as standard.

Position of the water connection if a 3 m hose is used. This hose is available from our customer service department.

Instructions for trained personnel

Connection to the water supply

Please read the ﬁrst three points of the safety instructions and warnings before connecting the appliance to the mains water supply.

The water pressure must be between 1,5 and 6 bar. The water supply to the appliance must be through a cold water pipe that can withstand the operating pressure and complies with the hy- giene regulations. For this, use the stainless steel hose supplied (length 1.5 m).

An extension hose of either 1.5 m or 3 m is available from the customer service department which must be assembled by a technician.

A shut-off valve must be installed between the hose line and the house mains supply so that the water supply can be stopped if necessary.

Connect the straight section of the supplied stainless steel hose to the shut-off valve. There is a screen and seal in the connector.

Connect the angled section of the stainless steel hose to the solenoid valve. The water connection to the appliance is via the solenoid valve on the rear of the appliance. The connec- tion dimension is R 3/4.

Before the appliance is used for the ﬁrst time the system must be bled of any air by a competent person (i.e. Plumber)

1.Open the shut-off valve for the water supply and check

the entire water system for leaks.

2.Insert the mains plug for the combined refrigerator-

freezer into the socket.

3.Move the combined refrigerator-freezer into its intended ﬁnal position. Ensure that the water supply pipe is not damaged or kinked as you do this.

All equipment and devices used to supply the water to the appliance must comply with the current regulations of the country concerned.