Putting into operation
4.1.2 To change the hinges
Fig. 4
uLift off the covers Fig. 4 (5,6,7,8) forwards using a
uLoosen the top and bottom screws Fig. 4 (9) on the appliance body, without removing them.
uPull the doors outwards and detach them.
uTransfer the screws Fig. 4 (9) to the opposite side and screw them in a little.
uUndo the screws Fig. 4 (10) and change over the hinges di- agonally.
The screws Fig. 4 (10) are
u Screw the hinges tight.
u Place plugs Fig. 4 (11) in the now unused fastening holes. u Attach the doors to the prefitted screws Fig. 4 (9) and tighten
the screws.
4.1.3 Re-fit the soft stop mechanism
Fig. 5
uFasten ball stud Fig. 5 (3) in the new fastening hole.
uPush tension spring Fig. 5 (11) inwards again.
uScrew on holder Fig. 5 (1).
uAttach soft stop mechanism Fig. 5 (2) to ball stud.
4.2 Water connection*
WARNING
Danger of electric shock!
u Disconnect the appliance by unplugging it before you connect it to the water line.
u Shut off the water supply before you connect the water feed lines of the IceMaker.
u The connection to the drinking water system may be carried out only by a qualified gas fitter and plumber.
WARNING
Risk of poisoning!
u The water quality has to comply with the drinking water ordi- nance of the respective country (e.g. 98/8
u The IceMaker serves exclusively for making ice cubes in household quantities and has to be operated with water suit- able for the purpose.
- The water pressure has to be be- tween 0.15 MPa and 0.6 MPa. (1.5 bar- 6 bar)
- The water supply to the appliance must be via a cold water pipe which withstands the operating pressure and complies with the hygiene regu- lations.
Use the accompanying stainless steel hose (1.5 m). Do not reuse old hoses. A 3 m hose is available from the customer service department and has to be fitted by an expert.
In the hose connecting piece is a sieve with seal.
- Between the hose and the domestic water connection there has to be a stopcock to interrupt the water supply in case of need.
- All the fixtures and fittings used for water supply have to comply with the applicable regulations of the respec- tive country.
- Do not damage or kink the water inlet pipe when installing the appliance.
uConnect the straight part of the accompanying stainless steel hose to the stopcock.
The solenoid valve is at the bottom back of the appliance. It has a metric R3/4 connecting thread.
u Connect the angled part of the stainless steel hose to the sol- enoid valve.
u Open the stopcock of the water supply and check that the entire water system is leakproof.
Before initial use:
u Have the water pipe bled of air by the proper ex- pert.
4.3 Installation
All the mounting components accompany the appliance.
5