Installing the appliance | Liebherr 110309 7084282

Putting into operation

4.3.1 Installing the appliance

Fig. 8

uDetach the connecting cable from the rear of the appli- ance. Remove the cable holder otherwise there will be vibratory noise.

uLay the connecting cable with the help of string in such a way that the appliance can be easily connected following installation.

Fig. 9

For appliances with permanently plumbed in IceMaker: u Connect the IceMaker (see 4.2) .

All appliances:

u Slide the appliance 3/4 of the way into the recess. u Remove the covers Fig. 8 (5,6,7).

u Fit the equaliser trim Fig. 10 (20) concentrically onto the appliance: Slide it into the recess and engage it in the keyholes.

Fig. 10

u Screw all the mounting brackets Fig.11 (34) to the pre-drilled holes in the ap- pliance door using hexa- gon screws Fig. 11 (35).

Fig. 11

For 16 mm-thick unit walls =

568 mm-wide recess:

u Clip spacer Fig. 12 (23) onto the upper hinge and spacer Fig. 8 (24) onto the lower hinge.

Fig. 12

u Attach the top cover Fig. 13 (53) and bottom cov- er Fig. 13 (50) to the mount- ing brackets.

u Fasten the mounting brack- ets Fig.13 (50) at the top and

bottom with screws Fig.13 (51) so that the brack- ets can still be moved a little to the left and right.

Fig. 13

u Strip the protective film off the cover trim Fig. 14 (22). Apply the cover trim Fig. 14 (22) to the projection of the cover Fig.13 (53) on the handle side, flush with the front, and adhesively affix it to the side wall of the appliance.

u If necessary, shorten the cover strip Fig. 14 Fig. 14 (22) at the bottom: The cover strip

Fig. 14 (22) has to end 3 mm above the up- per edge of the lower mounting bracket Fig. 8 (50).

Slide in and align the appliance:

u Slide in the appliance until the covers Fig. 13 (53)abut Fig. 13 against the side wall of the kitchen unit.

u Extend the adjustable foot.

For 16 mm-thick unit walls =

568 mm-wide recess:

u Allow the spacers to abut against the side wall of the kitch- en unit.

Fig. 15

For 19 mm-thick unit walls =

562 mm-wide recess:

u Align the front edges of the hing- es so as to be flush with the side wall of the kitchen unit.

Fig. 16

For kitchen units (16 mm and 19 mm) with door stop components (knobs, sealing lips etc.):

u Allow for the extra distance (depth of the door stop compo- nents): Allow hinges and covers Fig.13 (53) to protrude by the extra distance.

All appliances: