Demo mode
This mode is intended to be used in shops to demonstrate the oven functionality without any power consumption except the interior light, the display and the fan. This function can only be switched on when the appliance is first connected.
If there is a power failure, when the power supply is restored again, the Demo function can only be switched on if in the display 12:00 and the symbol
are flashing automatically.
1.Press the Time functions button for approximately 2 seconds. An acoustic alarm will sound for a short time.
2.Press the Time Functions and “ ”buttons at the same time.A short acoustic alarm will be heard and the time 12:00 will appear in the display.
When the oven is switched on the symbol appears in the display.This means that the Demo function is activated.
All oven functions can be selected.
The oven is not really working and the heating elements do not switch on.
Switch off the oven and follow the procedure described above to switch off the demo mode again.
The Demo function remains saved in the programme in the event of a power failure.
Error code
The electronic programmer does a continuous diagnostic check of the system. If some parameters are not correct, the control unit will stop the activated functions and it will show on the display the corresponding error code.
For further details, refer to chapter "Something not working“.
Beep mode
You can choose to make The Electronic Control beep each time that a control is touched.
To enable this function, the oven must be off.
Press controls Oven function and “ 
“ at the same time for about 3 seconds. The Electronic Control beeps once.
To disable the "Beep" Function:
1.If the oven is on, press control 
to switch it off.
2.Press controls Oven function and “ 
“ at the same time for about 3 seconds. The Electronic Control beeps once.
16