John Lewis JLDW 1221 instruction manual With some malfunctions, the display, Shows an alarm code

Page 24

	described in the table, without calling out an •		- The anti-flood device is on.
	engineer.		Warning! Switch off the appliance
	With some malfunctions, the display
			before you carry out the following
	shows an alarm code:
			suggested corrective actions.
	•	- The appliance does not fill with

water

• - The appliance does not drain the water

Malfunction	Possible cause	Possible solution

The appliance does not fill with	The water tap is blocked or	Clean the water tap.
water.	there is limescale on it.

	The water pressure is too low.	Contact your local Water
		Authority.

	The water tap is closed.	Open the water tap.

	The filter in the water inlet hose	Clean the filter.
	is blocked.

	The connection of the water	Make sure that the connection
	inlet hose is not correct.	is correct.

	The water inlet hose is	Make sure that the water inlet
	damaged.	hose has no damages.

The appliance does not drain	There is a blockage in the sink	Clean the sink spigot.
the water.	spigot.

	The connection of the water	Make sure that the connection
	drain hose is not correct.	is correct.

	The water drain hose is	Make sure that the water drain
	damaged.	hose has no damages.

The anti-flood device is on.		Close the water tap and
		contact our extended warranty
		administrators. Refer to
		'Repairs - after sales service'.

The start of the washing	The appliance door is open.	Close the appliance door.
programme does not occur.

	The mains plug is not	Connect the mains plug.
	connected in the mains socket.

	The fuse in the fuse box is	Replace the fuse.
	damaged.

24

Image 24

Contents Jldw Dishwasher Important safety information InstallationChild safety General safetyMaintenance and cleaning Service Correct useEcological hints Environmental informationContents Description of the appliance Detergent dispenserRinse aid dispenser Worktop Control panel On/off buttonProgramme buttons Multi tab buttonDelay start buttons IndicatorsSetting mode DisplayOnly one programme indicator comes on Washing programmesWhen the appliance is first installed Water softenerConsumption values Setting manually Setting electronicallyRelease function button B and function button C Switch off the appliance to confirm the operation Filling with saltFilling with rinse aid Display shows the current level e.g. displayed = levelAdjusting the rinse aid dosage Daily useLoading cutlery and dishes Start the washing programmeLower basket Cutlery basket Upper basket Adjusting the height of the upper basket Use of detergent Moving the upper basket to the higher positionMoving back the upper basket to the lower position Multi tab function Fill with detergentStarting the washing programme without delay start Starting the washing programme with delay startSelect and start a washing programme Hours are no longer flashing but fixed with static lightCancelling the delay start Cancelling the washing programmeInterrupting a washing programme in progress Countdown has not yet startedUnloading the appliance Maintenance and cleaning Cleaning the filtersFrost precautions Cleaning the applianceSomething not working Prolonged periods of non-operationShows an alarm code With some malfunctions, the displaySuggested corrective actions Appliance does not fill withWashing and drying results are not satisfactory Activating the rinse aid dispenser Technical data InstallationUnpacking Fitting under the kitchen worktopLevelling of the appliance Removing the appliance worktopWater connection Water inlet connectionWater drain connection Page Electrical connection Repairs after sales service Made even if the appliance is under guaranteeSpare parts ModPage Page Page 117938390-D-032011 Subject to change without notice