Drain Pan and Light Shield Removal
Light Shield
Drain Pan
SERVICE INSTRUCTIONS
OPERATION CONDITIONS AND PRESSURES
To remove the drain pan, remove screws along the front face of the drain pan. Lift the rear of the pan up and out of the drain trough. Slide pan towards you and out.
Reverse procedure to install.
To remove the light shield, remove screws along the front face of the light shield. Pull the light shield towards you and out. Reverse procedure to reinstall.
With room ambient temperature of +80 oF and cold cabinet (unit cycling on control):
Suction pressure – 5 to 9 psig.
Head pressure – 210 to 260 psig.
Typical operating pressures for a properly charged unit operating at 0°F or lower box temperature, check pressures immediately before normal off cycle expect a tolerance of ± 5 psig high side, and ±1 psig low side.
11