Panasonic WV-NP472E Set to on if your internet Internet service provider uses a

	Secondary server	Set the IP address of DNS when using the DNS server.
		Refer to your internet Internet service provider for the IP
		address of the DNS. Primary and secondary IP addresses
		can be set for the DNS.
	DHCP	Set to ON if your internet Internet service provider uses a
		DHCP server (the DHCP server assigns an IP address to the
		camera automatically) after confirming that your internet
		Internet service provider uses a DHCP server.
Connection type 4	IP address	The setting differs depending on the setting of the router as
		follows.
		If the router uses DHCP: No setting required
		If the router does not use DHCP: Assignment of a private IP
		address to the router is required. However, the IP addresses
		already assigned to the PC and other cameras are not avail-
		able.
		For further information, refer to the operating instructions of
		the router.
	Subnet mask	The setting differs depending on the setting of the router as
		follows.
		If the router uses DHCP: No setting required
		If the router does not use DHCP: Setting of the subnet mask
		is required.
		For further information, refer to the operating instructions of
		the router.
	Default gateway	The setting differs depending on the setting of the router as
		follows.
		If the router uses DHCP: No setting required
		If the router does not use DHCP: Assignment of an IP
		address to the router is required.
		For further information, refer to the operating instructions of
		the router.
	Network speed	Set the network speed.
		Use the default setting “auto” for the network speed.
		Selectable parameters: auto (default setting), 100 Mbps (full
		duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10
		Mbps (half duplex)
	HTTP port	If multiple cameras are connected, it is required to set up
		each camera individually.
		However, the port numbers already assigned to other hard-
		ware are not available.
		The following are already assigned to the camera.
		Port number: 20, 21, 23, 25, 53, 67, 38, 80, 546, 547
		The following are not usable if the FTP client function is set to
		on.
		Port number: from 4000 to 5000
		The following is not usable if the custom alarm function is set
		to on.
		Port number: number already assigned to the custom
		alarm.

-27-