Remington EL-8: 107624-01, EL-8: 107624-02, EL-8: 107625-01, EL-8: 107625-02, EL-8: 111174-01

CLEANING AND

MAINTENANCE

Continued

4.Hold Þle guide level. Make sure 30° mark on Þle guide is parallel to center of guide bar (see

Figure 21). This will insure that you Þle cutters at 30° angle.

5.File from inside towards outside of cutter until sharp. Only Þle in this one direction (see Figure 21). Note: Two or three strokes with Þle should sharpen cutter.

6.After each cutter is sharpened, move chain for- ward to sharpen next cutter. File all cutters on one side of chain.

7.Move to other side of chain and repeat process.

Filing Cutter Depth Gauges

The cutter depth gauge clearance is reduced as cut- ters are sharpened. After every second or third sharp- ening, reset cutter depth gauges.

1.Place depth gauge tool (.025") Þrmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Figure 23).

2.Use medium ßat Þle. File depth gauge level with depth gauge tool.

3.Remove depth gauge tool. With ßat Þle, round off front corner of cutter depth gauge (see Fig- ure 24).

After several hand Þlings, have authorized service center or sharpening service machine sharpen chain. This will insure even Þling.

REPLACING SAW CHAIN

Replace chain when cutters are too worn to sharpen or when chain breaks. Only use replacement chain noted in this manual.Always include new drive sprocket when replacing chain. This will maintain proper driving of chain. Note: For proper chain and drive sprocket, see Replacement Parts and Accessories.

STORAGE

If storing saw for more than 30 days, follow steps below.

1.Drain oil tank.

2.Remove and clean guide bar and chain. Clean guide bar and chain by soaking in petroleum based solvent or mild soap and water mixture.

3.Dry guide bar and chain.

4.Place chain in container Þlled with oil. This will prevent rust.

5.Wipe a thin coating of oil over surface of guide bar.

6.Wipe off outside of saw body. Do this with soft cloth dampened with a mild soap and water mixture.

7.Store chain saw

¥in a high or locked place, out of childrenÕs reach

¥in a dry place

¥in a carrying case or with scabbard over guide bar

TECHNICAL SERVICE

You may have further questions about assembling, operating, or maintaining this saw. If so, contact DESA InternationalÕs Technical Service Department at 1-800-858-8501.

You can also visit DESA InternationalÕs technical service web site at www.desatech.com.

ILLUSTRATED PARTS LIST

See pages 46 through 50 for an Illustrated Parts Breakdown and Parts List.

REPLACEMENT PARTS AND ACCESSORIES

WARNING: Use only replacement parts and accessories described in this manual. Use of other parts or accessories could damage saw or injure operator.

See page 45 for a list of Parts Distributors near you. For a list of Authorized Service Centers near you, call 1-800-858-8501 or visit our website at www.desatech.com.

REPAIR SERVICE

Note: Only use original replacement parts. This will protect your warranty coverage for parts replaced under warranty.

Each authorized service center is independently owned and operated. For additional service center or warranty information, call 1-800-858-8501.

WARRANTY SERVICE

If saw requires warranty service, return it to nearest authorized service center. You must show proof of purchase. If faulty materials or workmanship caused damage, we will replace saw without charge.

NON-WARRANTY SERVICE

If saw requires service, return it to nearest autho- rized service center. Repairs will be billed to you at regular repair list prices. Note: Normal wear, mis- use, abuse, neglect, or accidental damage is not cov- ered under warranty.

107705 21 www.desatech.com